Recent content by 05mingreygt

I usually do. But it messed up half way through. So I had to switch to a reqular water nozzle and just tried to be carefull with it.

Anyone's car ever go into fail safe mode? Happened to mine a day after I washed my motor. So I think that's the problem. Thinking it might be the TPS sensor so I'm going to try changing that. Any other thoughts on what it could be? Or is it a list of things it could be? Any help is greatly...

Will do, the problem happened after it finished raining hard. Thanks for the help.

Has anyone ever had a problem with your turn signal bulb staying on? Not blinking, just staying lit. It's the pass front. Had to pull the fuse so it wouldn't kill my battery. Thanks for any help.

Thanks for all the help. Just wasn't sure if something was wrong. I'll talk to my tuner and see what he can do.

I have an 05 gt that I just recently installed FRPP hot rod cams. Got it tuned and it runs great. But when I first start it after it sits for a long time (over night), it revs up to about 3500 rpmfor about 10-15 sec and slowly idles down. Has anyone had this problem? And if so, how did you fix...

Sorry about the double posting. A buddy of mine posted this not knowing I did the other. And thanks for the info, taking it for a tune on Mon.

Went with hot rod cams. Havent had the tune done yet. Getting it done Monday. Got it to start today after tinkering with it a bit. Ran like $hit and ended up dying off. Hopefully after the tune it will be good.

Cam question. It starts, but it dies. I installed the cams. Followed the instructions to the T. Even rented to tools. The car starts up, but it bogs down and revs up a couple of times and then dies. Is that a tuning issue, or a timing issue? I was planning on tuning it, but don't know if that...

Swapped my cams on a 05 mustang gt. Followed the instruction from freedom racing to the T. Tried to start it up and it just turns. My gauge reads "0 miles to empty". MAF sensor wasn't plugged in. Disconnected the battery and i'm waiting right now. Any ideas what it could be. Any help would be great.

laying down some fire, nice!

Sounds great, putting in my hot rod cams Friday. Can't wait

I got a set of FRPP hot rod cams that I want to install in my 05 this weekend or next. Seeing if anyone in the DFW area might be willing to help or have the required tools, ie valve spring compressor or timing chain wedge. since I have never done a job like this, and I don't want to buy the...

Looks like it was a kick a$$ time. Sorry I missed it.

Thanks for the help everyone. Just saw all the instructions said use those tools, so I thought they were a must. But I may give it a go w/out the compressor.