Recent content by Bender

Could you have a machine shop make a cap that threaded on to the end of the O2 sensor with no hole in it for exhaust gas to flow thru then the cap could screw in to the x pipe. Sounds like the whole idea is to get the O2 sensors away from the exhaust flow. Just an idea if I'm wrong never mind then.

When you data logged it did you use just the hand held or did you do it using a laptop connected to the handheld? If you didn't do it with a laptop I would log it again with a laptop using livelink.

Pretty sure it is supposed to read 0. Mine was when I data logged and when I spoke with the tunner about it he said that's what you want.

My build date is 6/2011. This should be interesting.

True I saw that he listed the mount and dampener part number and asked if it was necessary. I gotta read better. I installed d specs with a prokit and the gt500 mounts.

I just installed a prokit on my 2012 and the upper mounts came apart when I disassembled the strut. Spend the 95 bucks for the GT500 mounts and be done with it.

I want to run 18 x 10.5 in the back so I can put 305's on it. I was wondering if anybody knew what the back spacing and offset would need to be. Thanks Ben.

Got mine yesterday and installed it last night. This thing is amazing. I had the hang ups everyone else talks about. A couple of things I did to make the installation easier was when assembling the 2 parts of the shifter housing I put the thicker piece in from the top then crawled under the car...