Recent content by Tbone

Found this troubleshooting guide, may help find where in the harness the short or open is. http://juchems.com/ServiceManuals/viewfile6aa8.pdf

Up here in canada i can go to canadian tire and "rent" a spring compressor. You pay full price just in case you dont return it, but bring it back and they give a full refund. Can do almost all specialty tools this way. Nothing in the US like that at an autozone or something?

Is by chance your passenger side floor wet? If the cabin filter area gets plugged water builds up and drips over the sjb, causing all sorts of problems. Like pull up the carpet and check.

cleaned the maf and made 100% sure its not flipped?

I did the same but my cruise has never worked since. Cruise control circuit high code. Redid all the connections and soldered but still doesnt work. Can you remember how you wired yours up?

Offtopic but that sounds like a good story lol

SCT x3 or x4 and a email tune is fine. Any decent mustang tuner can do a NA mustang email tune in their sleep. I even got hot rod cams and first tune from brenspeed is spot on, afr gauge reads great. Theyve tuned every combination known. If I was putting on a SC or turbo then I would get a dyno...

Hmm ya I like that. Ya I still have the oem rear springs. Think I'll give it a shot this weekend, should be easy to swap springs. I have 285/35/18 so only thing that may bug me is the wheel gap lol.

Hmm handles great and like poop lol....

With all the speed bumps and steep driveways in this town, im just tired of scraping over everything. I put in old style u clamps on the exhaust just so they scrape first before anything else. My question is, can I keep the front lowered and put the stock springs in the back, then go with a...

So a year ago, I installed a 2012 steering wheel in my 05 so I could have stereo controls on the wheel, and it's just a much nicer wheel. I got the stereo controls working great. But my cruise gives me a code about the circuit being hi. I assume resistance. I've resoldered the connections but...

I have hot rods and 4.10s. Love em. Still a little chug if idling along with no throttle. But I know it could be tuned out. I've driven another car with hot rods and 3.73s and it had no lurch at all. Brenspeed tuned for me, just haven't bothered them for a retune. Have the Rev limiter set for...

Clean the maf and throttle body blade. Easy next step and cheap. Solved alot of idle issues. Use maf cleaner only on the maf, and use it to clean the blade. You may of had an issue before and only noticed it after the install because you were looking for something that's wrong. Oh did you by...

Id drive it a while longer after resetting the pcm. It has an idle procedure to learn. Idle. The engine must be run for two and a half minutes with the air conditioner on and rear defroster on. The more electrical load you can apply the better. This will test the O2 heater, passive air, purge...

3M taped here, solid as a rock. The holes are locating holes only, dont help hold it on. Dont drill holes in your car!