Search results for query: *

Got the lights today. Worked on hacking my Driver Side Mirror tonight. Gonna finish it off with a little bit of JB-Weld to solidly hold the lamp in. FYI .. Crack is in my Garage Floor not the Light ... :)

I sold my Saleen Grill and wanted to included new Fasteners so I had to buy a box of 50 fasteners. The Grill uses only 8. So I have lots left over. I will sell them in sets of 8 for $5 shipped. I think Saleen gets $30 for them LOL ...... Let me know if you need them ... I have 5 sets...

Looking to get around $28K .... Low miles ..... See Sig for the major upgrades ....

I picked up a NAV panel pretty cheap to see what would work and what wouldn't. I figured the finished look would go nice with my Android Tablet Mod I did a couple months ago. The NAV panel does plug into the same Harness as NON-NAV panel ... However here is what I found out .. Night...

I've begun on building a tablet dock for my non-Nav equipped 2010 Mustang. If all goes as planned I will have fully functioning Sync as well as a docking for a 7" Android Tablet. I haven't decided which one yet ... but probably Either Dell or Samsung. The entire original sound system and...

Complete and ready to install. Upgrade your Base Model Plastic Dash to the Premium Aluminum Dash. If you are local and pick them up I will even install it for you .... $200 ...... I'll pay shipping to USA ... you pay PayPal 3% fees. Thanks ... Dan

I installed a FRPP GT500 pump setup a few weeks back. I was driving into work this morning wondering if both pumps were actually working. Outside of datalogging how would you verify? I figured if I pulled the factory fuel pump fuse from under the hood ... then the second pump should continue to...

Went to Car Show today with my 71 Maverick and not the Mustang. I was BSing with 2011 GT Convertible owner and he comes up with topic about hidden trunk lock cylinder behind rear seat. I said I had no idea what he's talking about but I knew my 2010 didn't have one. Sure enough he showed...

I've had my car for over a year ... and finally decided to take some pictures of it not in my driveway....

During my Dyno RUn I was monitoring my AEM A/F Wideband. What it is doing is bizarre ... it is reading 1 point leaner than the Dyno shops tailpipe sensor at idle. Dyno showed 14.4 at Idle and AEM was bouncing around 15.4 at idle. At WOT it is the Opposite ... It shows richer...

Stopped by Kurgan Motorsports today for a Dyno Run with Data Logging ... L8ohiLR9W-U Already talked to Jim at JDM ... I am Maxing out the Fuel Pump up top and he says I'm gonna need a GT500 Pump setup ...

I know lots of guys have removed your Shaker 1000 AMP/SUB .... This is a picture of the 10 PIN connector on a 2010+ AMP Does the 2005-2009 AMP use the same connector? Ford Does not sell the PigTail separate and I don't want to do to much hacking if I don't have too to install in my...

Been working on this since last Saturday ..... Pulls hard ... actually I think I smelled burning clutch already after the test drive! The JDM tune pulls really good when not in boost ... feels better than the N/A AM tune I had in there. The boost A/F stays in the 11's so I'm happy...

Would it make sense to install a Coolant Temp Gauge for a SuperCharger install? On either the inlet or outlet hose? The thought is that if the Gauge is reading LOW it may indicate the pump is not working .... any thoughts ??

I emailed Saleen the following question and wanted to get you guys input ... I just bought a Saleen SuperShaker for my S197 Mustang. I am installing a aftermarket Coolant tank in the empty space left from the AirBox Removal and won' be using the Saleen Supplied tank. Is it possible to...

SOLD!!!

Here are some pics ... just got it installed. I went with the Saleen Grill since I was not keen on the Billet Grill. Dealer sent me GT500 foglights instead of the correct CS projector fogs. The correct fogs are scheduled to be delivered on Monday ...