AlbertD
forum member
Just bought these wheels and tires last week with hopes to use them as a lightweight/sticky daily driver setup.
I failed to realize that my Moser axles didn't have the provision to mount the hub centric ring needed to properly position the rear wheels which ultimately resulted in several ruined wheel studs and lugs.
This setup has less than 50 miles and is in like new condition. Never raced, not even on long enough to do a burnout. There is only one small blemish on one of the rear wheels due to my trying to remove a stuck lug nut (shown in the pic below).
I have over $1800 invested.
SOLD
Included with sell:
(2) 17x7 Polished Racestars with 215/55/17 GoodYear Assurance Fuel Max tires and 07-09 valve stem type TPMS installed.
(2) 15x10 Polished Racestars with 295/55/15 Mickey Thompson ET Street S/S tires and 07-09 valve stem type TPMS installed.
(1) TPMS programming tool
(10) Racestar lug nuts and washers *Note: You will need to buy another pack of 10
(1) Thin wall socket for lug nuts
(4) Hubcentric rings
(4) Valve stems *Weren't used since TPMS was installed instead
Everything has already been mounted and balanced, ready to be installed on the car. Front wheels fit 4 piston Brembos and only modification required for rear wheels to fit is a rear sway bar relocation kit.
If you have any questions please feel free to ask.
I failed to realize that my Moser axles didn't have the provision to mount the hub centric ring needed to properly position the rear wheels which ultimately resulted in several ruined wheel studs and lugs.
This setup has less than 50 miles and is in like new condition. Never raced, not even on long enough to do a burnout. There is only one small blemish on one of the rear wheels due to my trying to remove a stuck lug nut (shown in the pic below).
I have over $1800 invested.
SOLD
Included with sell:
(2) 17x7 Polished Racestars with 215/55/17 GoodYear Assurance Fuel Max tires and 07-09 valve stem type TPMS installed.
(2) 15x10 Polished Racestars with 295/55/15 Mickey Thompson ET Street S/S tires and 07-09 valve stem type TPMS installed.
(1) TPMS programming tool
(10) Racestar lug nuts and washers *Note: You will need to buy another pack of 10
(1) Thin wall socket for lug nuts
(4) Hubcentric rings
(4) Valve stems *Weren't used since TPMS was installed instead
Everything has already been mounted and balanced, ready to be installed on the car. Front wheels fit 4 piston Brembos and only modification required for rear wheels to fit is a rear sway bar relocation kit.
If you have any questions please feel free to ask.
Last edited: