Aeroforce Interceptor Doesn't Power Up But Red Lights Blink

[Jon_Purdy]

Hello everyone. Just had the Aeroforce Interceptor installed and I was in the process of selecting the parameters I wanted to monitor and now the gauge doesn't power up but the red lights blink every few seconds. Any idea what is going on? What should I be looking at?

 

[stkjock]

did you test them w/ the OBD port prior to installation?

 

[Laga]

That gauge can be touchy. Unplug from port when car is off. Wait a couple of minutes. Plug back into port. Wait a couple of minutes. Start car. It should operate normally.