Installed it earlier right before I left work. Raptor's installation locations were good. I ran the wire through the passenger side firewall in the same rubber grommet where I ran my hot wire for the GT500 fuel pumps. Raptor harness is not nearly long enough so buy yourself some 20-22 gauge wire to install it. Didnt take any pics I was just trying to knock it out and get home to swap my drag radials on. Leaving the house at 6:30 am for an event at Silver Dollar Raceway. Hoping for 11's but expecting 12's. First time to the track since the supercharger install.
OH, it works GREAT by the way, so far... Played with it a little tonight but I'll get plenty of time with it tommorow at the track to give you a definitive answer.
Gremlin: That's just the shift light there. I have the dual-mode which also has a launch light. You have to tap in to the PCM for the dual-mode. Thanks though
i used the intrusctions from their website...however they were pretty vague. after i complained they modified their instructions to make them a little clearer