It's a fun project for sure waiting on special paint to finish it up. I used the boss 302 brace for my inspiration. Was what I had before and really liked it. I ended up with a 21 degree bend on one side and 22 on the other so both sides were within a degree of each other so I will take that. My rails are much higher and wider with this manifold so wanted to clear. But another hindsight I would probably move the bends 1-1.5" closer to center if doing again. Would still clear fine and put slightly less bend angle. This thing is frigging solid though, hefty brace for sure 1/8" thick steel throughout.