Garage clean up to fund my swap

[ellerstang]

All parts from 06 GT with a little over 16000 miles on them. They been sitting on the shelf for about 4 years just now cleaning up, didn't want to sell anything until I was sure I wasn't going to need any of it. Everything is priced for shipping. Any questions or need a close pic just ask. Located in Corpus Christi Texas.

Everything is OBO.

Pic with sig of everything together.


Stock intake manifold with plates - 100


Stock header manifolds - 60 just because it is heavy


Coolant overflow -sold


Charge motion plates- SOLD


Stock air box -40


Not stock JLT 4.5 MAF housing -80


Stock fuel rail -40


Stock throttle body no electronics-45
Saleen crossover. -65


Stock 06 Gt ECM - sold

 

[Macman45]

That radio isn't from an S197. We never had tape decks. Must be out of another Ford from similar vintage.

 

[dark steed]

I think someone was looking for an 06 ECM in the WTB section...

Edit: BMWM3 is looking for an 05 GT manual ECM. Not sure if this will work.

 

[ellerstang]

It came out of my cuzins s197 unless he pulled one over my eyes. O well disregard radio. Thanks for the info.

 

[Macman45]

Yup actually that radio isn't even for a Ford. It's a GM from 2002, Blazer/Envoy SUV

 

[ellerstang]

Yup actually that radio isn't even for a Ford. It's a GM from 2002, Blazer/Envoy SUV

Thanks. I took it down. Should of done my own research on it before posting it. Everything else came from my donor car.

 

[Macman45]

What all is left on said donor car? I'm looking for some interior trim pieces.

 

[ellerstang]

That donor car is long gone. I just posted it so everyone would know where I got my left over parts from.

 

[irishpwr46]

do you know if the stock cmcvs were in good working order?

 

[ellerstang]

do you know if the stock cmcvs were in good working order?

Just saw ur post the ones on the intake where working fine when pulled off. I'm not sure about the ones that are separated. Bought them from someone on here don't remember who and I didn't ask. But I can separate them from the intake. That came off my motor for the CNL manifold I installed instead.

 

[LCPLPunk]

Are the motion control plates still available?

 

[ellerstang]

Are the motion control plates still available?

i still have the ones off the intake just noticed your post
50 shipped

 

[LCPLPunk]

I got some already, thanks though!

 

[BMWM3]

payment sent for eCU

 

[stangguy07]

do you still have the stock plates off the intake manifold??