Installing a BMR k-member, need a little help please.

[snopro442]

So far most of it is going great up til now. The tie rods are being a pain in my ass. Whats the best way to remove them or can I leave them on? The lower a-arms are loose but the tie rods just don't want to break free even with hitting them with a hammer, bigger hammer???? Any help would be great! Thanks.

 

[skwerl]

You can leave the tie rods attached to the hubs or knock them out with a bigger hammer. By leaving them attached they hold the steering rack in place so you don't need to fight that as much.

 

[snopro442]

I just wanted to make sure that if I leave them on that I wouldn't wreck anything inside the rack. Thanks

 

[AndrewNagle]

Not necessary to remove them as Skwerl said and also in BMR's directions it says it is not necessary.

 

[skwerl]

Directions are for pussies!

 

[fdjizm]

Try butter ?

 

[snopro442]

I picked it up used with BMR a-arms and I didn't get any instructions. He had it on the car and didn't like the extra noise so he took it off.

 

[AndrewNagle]

I picked it up used with BMR a-arms and I didn't get any instructions. He had it on the car and didn't like the extra noise so he took it off.

Here yah go bmr instructions

 

[AndrewNagle]

Try butter ?

Parkay?

 

[TexasBlownV8]

+1 on leaving the tie rods attached if you can.