Pulling a seized motor with an A6

[cb900f]

Morning!

I'm in the middle of yanking my motor out. It seized up b/c I broke the oil pump gears. Anyhoo, I cannot rotate the motor to remove the converter off the flexplate. Will I damage the transmission pump if I yank it out with the converter attached? Should I just pull the transmission at the same time?

Thanks!

 

[cb900f]

Admin moved this to 4.6L Tech, this specifically applies to a 2011+ Coyote motor. Any help moving it there?

 

[cb900f]

Admin moved this to 4.6L Tech, this specifically applies to a 2011+ Coyote motor. Any help moving it there?

Blake Holcombe recommended to yank the trans out at the same time to not damage the pump.

Sent from my SM-N910V using Tapatalk

 

[onebadgsx]

i pulled mine with the converter on the motor, left trans in car. just support the trans. no issues at all

 

[cb900f]

i pulled mine with the converter on the motor, left trans in car. just support the trans. no issues at all

That would make it much easier...

Sent from my SM-N910V using Tapatalk