rear axle anti bottoming snubber part???

[snopro442]

does anyone make an aftermarket anti bottoming snubber that goes on the rear axle? I lowered my 06 gt and the axle is real close to the frame and the factory snubber on the axle looks pretty weak(poor rubber?) please post anything you know of, thanks

 

[Stangmeister9]

Just take a stake knife to it and cut'er down. No biggy! U dont even have to remove them from the car in order to trim'em

 

[RedMosesSC]

Dont be affraid to take off a bunch of it either, i had to cut mine down a few times to get it right because i dint want to take off too much. Cut it to about 50% its original height and trim from there if necesary.

 

[STEVE_POE]

hell just remove them. I did.

 

[kevinatfms]

^^^ same, may save an ounce or too! then you dont have to take a crap and vomit before you run to get a weight reduction

 

[ArizonaGT]

KW has some shorter ones that come w/ their kits, they might sell them separately. As far as cutting or removing the bump stops is concerned, they're like a spring: cut them and their effectiveness will be reduced if you need to lean on them, and if they're removed, well...