Recent content by 1ohiostang

  1. 1

    Freeze plugs

    I used the M-6026-A46 kit from Ford racing for my 3v.
  2. 1

    How would this look on a stock hood?

    Yes it lays on there pretty nice. The hardest part was lining up the bend down the center of the hood. Let me know if you want any other pictures
  3. 1

    How would this look on a stock hood?

    I have a Carters customs
  4. 1

    Flywheel help

    Dowels come with the exedy flywheel
  5. 1

    compression questions

    When I redid my motor I bump the compression up a fuzz to 10.25. I'm only running 12 psi. I can tell you off boost the drivability is much better.
  6. 1

    BOV Placement

    I have a 2200 also. Mine is mounted in the pipe coming off the blower before the intercooler. There is a spot behind the front bumper cover with enough room for it
  7. 1

    what did i do?

    Yep you killed your slave cylinder with no pressure plate for the slave push against it over extended
  8. 1

    Engine Rebuild Questions

    I'm running 10.25 compression with a paxton you'll be fine n/a. Modmax has a nice selection of rod's for you
  9. 1

    Hood Painting Cost

    Impressive
  10. 1

    Rear gears high(er) power centri

    I'm putting 580 to the wheels first gear is a little short with the 3650. Over all it runs out good.
  11. 1

    Rear gears high(er) power centri

    Don't fear the gear! I'm running 410s with the 3650. Helps with the soft bottom end with centrifical blowers
  12. 1

    Hood Painting Cost

    I was quoted 700 this summer for doing a glass hood by a local shop. With my car being black how bad could Cervinis be?
  13. 1

    Tremec 6060 in a 2007 GT

    When I was looking at the swap for my gt the hang up now is the Cross member. They are not made any more
  14. 1

    LITO where are you???

    Yes http://www.tudyno.com/ Depending on your mods

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top