Recent content by Chris Sparks

  1. C

    02 sensors and evap will not go ready.

    Also I know it is running Bosch o2 sensors because the Ford ones wire lengths were too short and is identical to what I pulled out it part number wise when I replaced the one 02 sensor three months because on the check engine light was on for it and no lights since because when it came on the...
  2. C

    02 sensors and evap will not go ready.

    I tried the second Ford drive cycle and I am still getting the o2 sensors and 02 heaters are not ready and I drove it probably about 60 miles yesterday on the highway on cruise control not going above 70 mph and minimize the fuel slosh and going above 40 mph on the open roads and fuel gauge...
  3. C

    02 sensors and evap will not go ready.

    Well I tried the ford drive cycle yesterday some good news the evap is ready but the 02's are not.I have to put in more fuel and get it above 3/4 tank and try it again hopefully the next round of driving will make the 02's ready.Tks for the input!
  4. C

    02 sensors and evap will not go ready.

    It tells me on my scanner that the O2 heaters and the O2 sensors are not ready and also the evap is not ready.I tried driving in different conditions Highway probably 120 miles round trip and city driving about 30 miles in total for two days and I was not a light foot in driving and was mostly...
  5. C

    02 sensors and evap will not go ready.

    I meant Flowmaster Exhaust
  6. C

    02 sensors and evap will not go ready.

    My 2008 mustang gt o2 sensors and evap will not go ready for the NJ emissions test!.I tried to go thru the state inspection and it failed to pass just after I registered it.The next day my smart /SJB went bad and taken care of from a local Ford dealer it probably was from the heavy rains that...
  7. C

    2008 mustang gt with no ac no oil pressure no fuel gauge no turn signals

    I pulled the smart board out and I saw some dried moisture marks on the connectors of the board and I saw on the SVT forum an 08 mustang with the same exact issues and the problem FORD thought was the board was bad but found a bad wire to the board but I did not see any and practically pulled...
  8. C

    2008 mustang gt with no ac no oil pressure no fuel gauge no turn signals

    The blower is working but the ac compressor is not working
  9. C

    2008 mustang gt with no ac no oil pressure no fuel gauge no turn signals

    I check all of the fuses and swapped relay's with no resolve!.I looked at some of the wiring harnses nothing obvious.I drove the car a couple of days ago and ran it over 120 miles with everything working fine.I had the car for over a year with none of this happening!.I had to fix front end...
  10. C

    csparks08 2008gt with no ac,no radio,no gas gauge,no oil pressure no turn signal.Possible smart...

    csparks08 2008gt with no ac,no radio,no gas gauge,no oil pressure no turn signal.Possible smart board? floor board dry.Help me!
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top