Recent content by Drex

  1. Drex

    Do you have switchback (amber/white) turn signal bulbs for a 2014 GT500?

    Do you have switchback (amber/white) turn signal bulbs for a 2014 GT500?
  2. Drex

    WHICH TIRE WOULD YOU CHOOSE OF THESE FEW CHOICES? Any experience good or bad?

    Not listed, but I have been totally impressed with the Mickey Thompson Steet Comps I installed this spring. I previously had the Hankook listed and the Pirellis that came on the car. Both were decent tires but wheel spin was terrible - even in warm/hot temperatures. The MTs ride fairly...
  3. Drex

    Reduiculously loud - looking for ideas

    Yea man. There are two inspectors here in Stuttgart - one young guy and the other older. The older guy is typical older German - by the book and a bit stuffy. The young guy can be lenient when it's not a safety thing - therefore; we try to time our inspection with the older guy's day off.
  4. Drex

    Reduiculously loud - looking for ideas

    Dude - that sounds frickin awesome
  5. Drex

    Reduiculously loud - looking for ideas

    Not winter cold - not yet - but nothing wakes the neighborhood I live in like my mustang. The houses/apartments are tall and close. I KNOW I am waking everyone up:evillaugh:
  6. Drex

    Reduiculously loud - looking for ideas

    Thanks fellas! I'll start shopping now. I will never pass German inspection anyway, much less making enemies out of my neighbors
  7. Drex

    Reduiculously loud - looking for ideas

    I just installed long tube headers and O/R X pipe with Flowmasters out the back. I knew it was going to be louder with this setup - but damn it is too raspy around 2500-3000. At idle it sounds great to me, but I can already see the looks from my German neighbors. I was thinking about having...
  8. Drex

    Idle rpms on cammed cars. What do you prefer

    127550s set at 750. 9LBypacV_4g
  9. Drex

    Valve Spring Selection

    One more question - by locking out the cams, will I have less low RPM HP/TQ?
  10. Drex

    Valve Spring Selection

    Thanks for the replies fellas. I'm having second thoughts about choosing 127550s now. If I had went with a NSR cam, I wouldn't be having this conversation! Honestly, my initial goal was to have a rough idle - which I could have gotten with a number of different grinds, but I wanted to use...
  11. Drex

    Valve Spring Selection

    Hello all, I am upgrading cams and need advice/opinions. I purchased Comp camshafts - part number 127550. These should be a nice addition to my TVS blown 4.6. The car has 3:73 gears and is a 5 speed. Other than the TVS, Roush catback, and one-piece drive shaft, the car is stock with 35K...
  12. Drex

    Question about Interior of a 2010 I'm looking at buying

    I ordered my 2010 with the same seats, albeit red with a white accent stripe. It is the 401A rapid spec option, and it should have the carbon fiber dash and brushed aluminum shifter as well. It's a nice option. My wife talked me into that option when I ordered the car. It was a promotion...
  13. Drex

    Bitburg Drag Races: June 8-10

    Anyone going this weekend? A country worth living in is a country worth fighting for.
  14. Drex

    2011 Fastback Reversion

    Frickin sweet looking car! A country worth living in is a country worth fighting for.
  15. Drex

    Stock Clutch Question

    My stock clutch was slipping noticeably in 4th at WOT. The car actually drive fine around town and in low gear would accelerate hard without any indication (seat of the pants). It wasn't until I installed my Exedy that I knew how bad the sticker was slipping. I am at 482 WHP and 460 WTQ. A...
Back
Top