Separate names with a comma.
Same wheels I run 18x9/18x10 AMRs
If its been vibrating that bad it needs to be fixed ASAP, my mechanic checked my 410 gears(installed before I bought car). He didn't let car leave...
I would disconnect drive shaft at diff as suggested, would narrow it down to either tranny or diff.
Not sure on cost, but a lot of the car shows use them. Iron Resurection only uses them on their builds
Have you looked at Budniks
Is your axle centered ?
What are you running for shocks, are they doing any dampening at all
Great write up, I have a #1 on my counter.
That sucks, hate to see cars/trucks rust like that
Actually the whole job looks great
Seat delete looks good
I have 18" AMR's and they fit fine, front and rear (18x9, and 18x10)
Same thing I told him
Got them from somebody here in Tucson, ended up they worked where I did
I bought a windshield wiper puller on amazon
I got the Brembo 4 piston off a GT500 for $100
Must have gotten one of the last kits
SR under drive pulleys are SFI certified
Thanks Milton, Sure interesting for price, most kits are $5-7 k
Interesting, CX racing says $3100 with turbo upgrade, what else is needed ?
Injectors(lbs needed 39 or 47 ?)
fuel pump upgrades(what is needed?)...
Vorshlag did sell the kit, caliper brackets, rotors, calipers and pads. That,s what I used on my car. I didn't see it on their web page, when I...
I'd replace the cover
Holy old thread
I did the upgrade to the front and rear, 13.8" on both. Forgot about the spare, glad I didn't need it.