Search results for query: *

Can someone help me identify what is going on with my rebuilt engine!? 2005 Mustang 4.6 3v Brand New JE forged pistons Brand New Mahle valve seals Brand new Ferrea valves Brand new Autolite HTO spakplugs Recently did a cam phaser job on the drivers side head and wanted to check the bores...

Can someone please help me out! I've been searching for 2 weeks after installing an engine and I can't remember where the last piece of the harness connects to. It's a 2005 Mustang 4.6 Manual Transmission and the one connector I have left over is an eyelet on the passenger side right after the...

Looking for an extra set of hands for a manual 4.6 conversion and rear end swap. Any help would be greatly appreciated!

Ive recently come across an 01 Cobra Crankshaft for my 05 3v 4.6. The crank has been turned -0.020 and the machinist say that there are no bearings to fit! Can anybody point me in the right direction? This is just to hard to believe. Crank is forged for standard/manual coming from a 4valve...

Quick question... I am swapping from the 4.0 to the 4.6 and will also swap from auto to manual. Using my stock 4.0 Dash harness, which wire(s) will the clutch safe start connector need to be spliced with? If possible can you provide a photo or diagram? Thanks Guys

Hello Gents... trying to figure out if I should rebuild my 281 with Kelloggs stroker crank or if I should keep the stroke the same and just go with Manley Forged pistons and rods? Hmmm, Also how much horsepower can our stock Crankshaft hold up to on a continual basis? And I guy quoted me 8k on a...

Hello gentlemen, I am in a very sticky situation and I need your help and expertise!!! I have recently purchased a 2001 Cobra motor, T-45 Manual transmission, engine harness and computer for $1600. I've had the block rebuilt with Forged everything! 5.0 Stroker crank, 8:5 Dome top pistons...