Search results for query: *

I have had my PA alt on for 4 years now with no problems?

I installed a Kenwood DMX7706S Media receiver with 4 6x8 JBL GX speakers and a Kicker CX 360 watt 4 channel amp. Installer put in a special little kit so I can still use the door subs without the thump. Been VERY happy. I am into my music weather at home or on the road. BTW I also installed a...

I installed a AM PA performance 130 amp (323.00) and a PA performance Prem wire kit (69.00) and I run 4 100 watt amps. Been very happy.

The injectors on a mustang typically need around 39 psi so put a pressure gauge on the fuel intake line.

Good Info!! Thanks

I had a simular problem and after a lot of hair pulling found that I had a intermittent cell in the battery that sometimes tested good then would go bad. New battery fixed it. I had it tested several times and it tested good then one time finally not.

So your saying the wires should be already there but I will need to swap out fuse panels? I have seen some bases lately on e. Thanks

Hope I have the right forum? Has anyone installed a used power seat base on a non power seat passenger side. Problems ? Thanks

I had the same problem on a 08 and it was the battery. It was fairly new but It had a bad cell and would show a full charge but the cell would go out intermittently

I found out. It’s for adjusting the headlight. Thanks

I just replaced my driver side headlight and noticed on the back (other side also) it has a second bulb plug marked 12V?? It has no bulb or wires going to it (Halogen lights) but it looks like it would illuminate the shark slits on the side of the light? 2008 Mustang GT Thanks

Well I went with a Kenwood DMX 7706S it looks like it has all the options I wanted and was in budget. Install went easy and it sounds great looks great to along with backup camera. Integrated with my I-Phone like it was made by Apple and having access to SIRI while driving is great!! Thanks...

410's if manual get the Ford Racing-good fit and unless you have done this before have someone do it for you if you want to avoid whine as it requires special tools to set lash and clearance and experience.

OK with the help from you folks and Crutchfield I got a Kenwood DMX 7706S. Got the voltage regulator for 5V also. Thanks

2008 with a Shaker 500 Thanks all!

Would like Siri voice control and I use a I phone. SD slot Good EQ for great sound Easy controls. Single or Double DIN

I have been looking everywhere trying to get some current info on a good head unit currently made to replace my old one. I will be keeping the Shaker door subs and need hands free calling. Thanks

I also have this problem. What amps and speakers would you suggest for the door subs as the originals are a low impedance dual coil.

so you would be better not replacing the door subs unless you want to get into a deep R&R

Be aware also that the door subs are of a low impedance load that was matched to the amps behind the drivers side kick panel I believe.

That’s what they do on this unit on U-Tube. Might as well replace the head unit at that point. Best head unit option anyone?

I am having exactly the same problem and was wondering about the best fix along with how to get my CD’s out of the head unit?

I would check the thermostat and the water pump.

Maybe the stipes and were a dealer add on:rolleyes:

Please Need a few thoughts folks. I am 65 and have limited (as most of us do) funds. I am willing to do this in steps. So, my joy is a 2008 GT with stick shift. I have put in the following: 410 Ford racing gears CAI intake SCT Flash with re-programmer Flowmaster 40’s exhaust-axel back MGW...