Search results for query: *

  1. S

    help/info on bad wheel hop

    Well mine felt fine on the burnout. And 1st to 2nd felt fine. Hardly any nosedive
  2. S

    help/info on bad wheel hop

    Interesting. Well we've ruled out LCA cause they are parallel to chassis when load is applied to rear. But that was a thought till we figured that part out
  3. S

    help/info on bad wheel hop

    275-50-15 mickeys DR. Can't do et streets. My setup is for daily driving. Still got stock driveshaft also and stock shocks
  4. S

    help/info on bad wheel hop

    Hmm ok so should not be shocks. Ok what would you think would be the issue ? Pinion angle? Maybe something else? How was you leaving off the line? Dump or ride clutch? And what rpm was you leaving at? Also what was your pinion angle set at? And what springs did you have?
  5. S

    help/info on bad wheel hop

    went to track sunday on new wheel and suspension setup, adj upper set a -2 pinion angle, LCAs at bottom holes in relo brackets, when load is applied to rear, pinion is parallel to driveshaft, and LCAs are parallel to chassis, still have stock shocks and stock upper bushing in center of rear end...
  6. S

    what would win???

    damn # 2 driver. i want to see a car with less done to it run someone with more stuff and beat him, that my friend is someone that can drive:thumb: N/A all the way :asshat:
  7. S

    racestar wheels

    yep nice wheel :-) yea you see how they have the seat for the washer. weird but interesting design to fit multiple cars. but they work. yea see if you try to tighten the lugs at high noon the washer would fall out the seat and bind, but they look good, post a pic of them on the car so we can see...
  8. S

    racestar wheels

    that looks like the same thing, just older, chase them, and test fit each lug first then install and enjoy
  9. S

    racestar wheels

    Well it's hard to mess it up. Your not making new threads. Your just chasing them to clean them up. No biggie
  10. S

    racestar wheels

    yes when you put each lug on in the 6 oclock position, youll see that the fat end of the washer hangs down and thats where it will seat itself flush. if you tighten the first lug before you put the rest on it will be hard cause the, rim cant move around and it will bind. PM me if you have any...
  11. S

    racestar wheels

    put the ring on the car, then put the wheel on, like i was saying after yesterday i broke more studs, if youve taken your wheels off a few time, before you put your new lugs on, run a tap over each stud about 2 times, to make sure they are clean and nothing in the channels, test fit each lug all...
  12. S

    racestar wheels

    Updated info with lug nut/stud issues on racestars. After breaking 3 more studs. Got to looking more and came up with the fix. Lugs are not the issue if it's not a bad casting. For anyone with highly used stock studs that constantly take lugs on and off to swap wheels. Or etc. The studs threads...
  13. S

    pinion angle question

    How's your jms tunes compared to Wes tunes?
  14. S

    pinion angle question

    That would be me. How you know me? Not sure I remember if I ever meet you
  15. S

    PO133&153 codes

    had the p0133 code, checked the pids to the 02 sensors, and one 02sensor was not functioning properly, replaced them and checked pids again and 02s were working normally. 02s or the tune, the bosch 02 are only about 50$ each through oreillys, so it can go either way, if you can plug a computer...
  16. S

    WOTBOX and hella backfires/popping?

    good deal yea try 5k first and see if it gets better. now remember it will pop with the amount fuel your spitting but it might be less noticable, cause the motor is turning faster, i think i worded that right. let me know what happens im curious
  17. S

    pinion angle question

    nope last guy i tried was cody and lets say i did not like his tunes, they where well you get the idea. when you gonig back out to state capitol?
  18. S

    pinion angle question

    Wes at TPS in prairieville. I try to do my tunning locally
  19. S

    WOTBOX and hella backfires/popping?

    Oh no I'm N/A. No power adder. My 2step is set at 6k for down here. They are pretty good at preping the track. In my understanding if you have the boost set for a certain max psi it should not go over. I would one time test the 2step at 2500 and see what it does. And test it at 5000 and see what...
  20. S

    WOTBOX and hella backfires/popping?

    7-8 seconds damn, i always roll and stage first so im not rushing at the last second, once i see the other guy stage i enable my 2step and 2-3 seconds later im gone, the light guy is pretty on key with starting the lights down here. just a thought you can try, cut down on time and see if it...
  21. S

    WOTBOX and hella backfires/popping?

    that sounds weird. cause my understanding is that even if a little fuel gets into the cylinder when the piston comes up and the exhaust valve is open it should push most of the fuel out cause you to see it out the tailpipe. now my setup is just motor, but it sounds like something aint right...
  22. S

    WOTBOX and hella backfires/popping?

    have you ever had a good launch off the 2 step, or does it fall flat like there is no power when you launch off 2step? reason im asking is do you have code p0300 turned off, which is multiple random misfire, if that code is not turned off the car will act funny when trying to launch off 2step.
  23. S

    WOTBOX and hella backfires/popping?

    if you have the N2MB wotbox the box should be tied inline with the main wires for all 8 coils, not the #8 coil, that way when it cuts ing, it cuts to all 8 coils for the millisecond that you set it at. also with that setup if you set it anywhere from 75-150 milliseconds most of the time...
  24. S

    pinion angle question

    cool cool, state capitol here to, no problem is too damn far to drive for me, way out in the sticks.
  25. S

    racestar wheels

    i thought about the 15x5 also but the 15x3.75 really aint too bad down here, very suprised how they handle, the car is not very loose at hwy speeds, just a little in turns, but hell it feels good at 70mph on the interstate.

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top