BMR Pandhard Rod Support

[luillo]

I got the BMR Pandhard adjustable installed and try to install the support bar but there is no way to put that thing. i try upside down but no luck.

The website says it has a light bent to give more clearance for the exhaust but that bent gives me less clearance than the stock one.

Am i Doing something wrong????

 

[luillo]

Here is the stock one right were the BMR has the bend up then it touch the exhaust.

 

[GeorgeInNePa]

N/M, I was mistaken...

 

[Rob72]

Had it upside down huh?

 

[luillo]

Had it upside down huh?

Nope,,, The bar goes only one way. I try to put it upside down but if i do that the holes for the 2 screws on the other side will not line up with the holes in the chassis and the bracket on the BMR Bar where the holes are will not be flush to the chassis to line up the screw holes.

I will have to call them and if i cant figure it out then i will get the bar straight by cutting it and welding it or something like that.

hahahah

 

[Rob72]

My BMR support brace bolted in with no modification. I think I did twist the mufflers or pipes a bit to get more clearance. Can't remember exactly.