Exhaust set up

Goody05

forum member
Joined
Jan 8, 2012
Posts
219
Reaction score
0
Location
Omaha NE
Lol.....it's a 05 gt with part streetscene and part gt500 bumpers, I had the gt500 bumper top fused with the streetscene bumper lower, streetscene side skirts, and a modified Saleen rear end.....

Nice it looks good, but I was talking about the exhaust combo lol.
 

antant77

forum member
Joined
Mar 24, 2012
Posts
146
Reaction score
0
Location
Philadelphia, PA
Here goes again!, lol. Sorry bout this, kinda new with it

It looks the same as my first one....this is how the code looked:
780E47F7-6805-4F07-91BF-51A50DF0935B-1904-0000019EDADB6666_zps2410572a.jpg


 
Last edited:

speedfreak1000

2 sided tape expert
Joined
Aug 18, 2012
Posts
1,908
Reaction score
0
Location
Springfield KY
i love that low down lope it has, i little raspy up high for me but it sounds AND looks great. i like the red in the interior
 

antant77

forum member
Joined
Mar 24, 2012
Posts
146
Reaction score
0
Location
Philadelphia, PA

NotaHybrid

I'm slow
Joined
Sep 18, 2012
Posts
1,191
Reaction score
0
Location
Mobile, AL
How hard was it to hook up the prochamber with those long tubes? Anything special?

Sent from my helicopter
 

antant77

forum member
Joined
Mar 24, 2012
Posts
146
Reaction score
0
Location
Philadelphia, PA
How hard was it to hook up the prochamber with those long tubes? Anything special?

Sent from my helicopter

Nope!, not hard at all, just two sections of stainless steel pipe about 6-8 inches long (in the pic the two sections of pipe were from the exhaust shop, they cut them and flanged the one end)..Once i installed the LT I slide the flanged side of that "extension" tube over the LT collector and than u can see how much more you have to trim off of them extensions with the prochamber connected to the over-axle pipes...once the extension is trimmed to a good length you just slide the flanged end of the prochamber over the end of the extension....I bought 4 band clamps, two for each side for the collector, and two for the prochamber!

Also, some have said to relocate the hangers on the prochamber but after it was all hooked up and connected to the LTs and the over-axle pipes it was SOLID!! I do not have mine attached to the hangers at all and it's all good!!!

8BD2A2D9-E72E-405B-A6D9-18946D71B4EC-581-0000007B4D3EB704_zps2d85adf6.jpg


5D152713-F392-4FD5-912E-BE5FDB4CE236-581-0000007E3BADF2F2_zps0625134b.jpg


43B8AAEF-4ED5-4587-B917-E707AAC43966-581-0000007F14F476F6_zpsecdbe3f1.jpg
 
Back
Top