07_mustang_gt
Junior Member
- Joined
- Sep 26, 2016
- Posts
- 10
- Reaction score
- 0
OK so I am planning a build, and wanna get a little more insight on the when situation. Gonna be using a cast iron 4.6 Romeo block, 3v top end of course. Looking to build it capable of handling 7-800 HP, forced induction, for future plans, so a streetable 5-600 to start. Would like advice and combinations on what works best and most reliable for a daily as well. Stroker or keep stock stroke? I have used engine dyno sims for pushrod engines, as well actual blueprinting that were pretty accurate, but have not located or obtained enough info for the mod motors for programs similar. Any and all advice is appreciated thank you. And if this has been covered before apologies for posting again just point in the right direction thank you