Got some traction finally and ran 11.62 n/a '12 gt

[01bluesnake]

Finally got to the track and was able to hook thanks to new M/T slicks (3053S) and good prep. It is still a 3.31 gear car, with the exception of a 26" slick out back (26.5 actually). The car is still on stock control arms and shocks out back, otherwise i would of tried to dial in the '60 more, but that was about all it could do. For power mods, the car has GT500 mufflers, cat delete tubes, ported stock manifold and my tune. It has a few weight mods including BMR sway bar delete with tubular support bar, BMR K with stock arms, Dynotech DS, Weld RT-s wheel setup, and some FTBR prototype drag rotors. Suspension the car has BMR relo brackets and Steeda Boss springs.

Video's

GoPro 11.62 pass and some good shifting and 5300 2 step
bolt on coyote doin work - YouTube

12.0 pass off 3500 2 step

9/29 RSD- 01bluesnake's 5.0 vs. Built Evo - YouTube

Track stats:
Elevation 750ft
air temp 66*
humidity 50%
dew 47%
Baro 29.99

calculated DA for runs just under 1500ft

Run 1

reaction:-- .062
'60 foot:--- 1.59
330-------- 4.782
1/8 mile---- 7.419
1/8 mph---- 94.94
1000 ------ 9.699
1/4 mile---- 11.62
mph------- 115.66

DA corrected [email protected]

Run 2

reaction:-- -.058
'60 foot:--- 1.59
330-------- 4.814
1/8 mile---- 7.449
1/8 mph---- 93.98
1000 ------ 9.714
1/4 mile---- 11.62
mph------- 117.86


DA corrected 11.43 @119.8


A few still images of earlier low 2 step runs pulling the tires.

Low 2 step runs

Back to back 11.62 runs

 

[jodadejss06gt]

Very nice and pulling the right front tire! Congrats!

 

[fdjizm]

Awesome times man!!! i like the daylight under the front tire!

 

[TurboFocus]

nice times and loving both wheels in the air

 

[01bluesnake]

Thanks. I didnt believe when they were telling me i was pulling my tires, but after seeing some pics was pretty cool to see. I wish i had some driver side shots, friends said that one was coming up around a foot on some runs lol.

 

[AJCrader]

I have to admit, I am a bit jealous...CONGRATS!

 

[BMR Tech]

NICE!!!!!!

Thanks for choosing us for your suspension pieces.

What position are you currently running the LCA in on our brackets?

 

[BAKnBLK2010]

Car is doing serious work. Congrats!

 

[wbt]

Nice job!

 

[AJCrader]

My Bad wrong thread!

 

[DTony]

Great runs.

 

[01bluesnake]

Thanks Guys!

NICE!!!!!!

Thanks for choosing us for your suspension pieces.

What position are you currently running the LCA in on our brackets?

You are very welcome. I believe i spoke to you on the phone about my early K member, wheel shimmy concerns on these cars and when i ordered the panhard bar. Great products and service. I do still need to get some control arms but going to do that as a winter project. They were on the lower hole, but was running the middle previously. I think i need to put them back in the middle though since the angle on the arm looked to be too much. Thanks

Drew