Eboost2 install
Got the Eboost2 in the mail yesterday and got started on modding the roush vent pod to fit it. I thought it was a 66mm unit but it was the smaller 60mm unit which worked out great. Got lots of pics for ya.
I followed the roush instructions for installing the ventpod and they worked well.
The roush vent pod is designed for a 52mm gauge so i had to remove the inner ring and trim down the tabs to fit the 60mm eboost2.
After i had the inner ring dremeled out, i slowly removed plastic with the dremel evenly from each tab till the eboost2 would fit snuggly.
Some test fitting with the trim ring on
Got the Eboost2 in the mail yesterday and got started on modding the roush vent pod to fit it. I thought it was a 66mm unit but it was the smaller 60mm unit which worked out great. Got lots of pics for ya.
I followed the roush instructions for installing the ventpod and they worked well.
The roush vent pod is designed for a 52mm gauge so i had to remove the inner ring and trim down the tabs to fit the 60mm eboost2.
After i had the inner ring dremeled out, i slowly removed plastic with the dremel evenly from each tab till the eboost2 would fit snuggly.
Some test fitting with the trim ring on
Last edited: