Need moar low!!!

[Clipboard]

I have a Koni yellow/bmr spring setup and I would like to lower the back just a little bit more. I read about a heater hose mod that could do the trick, has anyone had experience with getting rid of the isolaters and putting heater hose on the spring? My friend suggested cutting the spring but I would really hate to destroy a nice spring.

 

[Wes06]

Dunno about heater hose but also you're friend, no reason to cut springs

 

[Clipboard]

I was thinking of airlift kit to get the height I want but if I can avoid spending the extra cash might as well...anyone have any ideas?

 

[Wes06]

As you can see I enjoy the airlift kit, but yea it's expensive

I'm sure there are springs out there that meet your needs

 

[Hvacmike]

When I installed my steeda competition springs I realized after I finished that I left out the isolators. I don't get any extra noise without them.

 

[GallopingFord]

Wheel gap is the enemy, eliminate it!

Don't cut springs.

 

[Doug M]

^^freaking show off

 

[fdjizm]

Wheel gap is the enemy, eliminate it!

Don't cut springs.

Herra frush bro

 

[Clipboard]

Wheel gap is the enemy, eliminate it!

Don't cut springs.

Airlift might be my only answer. I'm going to try and remove the isolators and put that heater hose on this weekend to try it out

 

[TGR96]

Classic S197 thread! Poor guy starts a thread with a simple quesion about lowering the car a little bit more, and by post 9, y'all have him ready to drop $4K on an airride setup!

 

[GallopingFord]

Haha. Just swap to lower springs. Eibach Sportline or HR Super Sports would work.

 

[Wes06]

Classic S197 thread! Poor guy starts a thread with a simple quesion about lowering the car a little bit more, and by post 9, y'all have him ready to drop $4K on an airride setup!

hey when you look this good you dont have to worry about that, cause 70k bitches!

 

[one eyed willy]

Just cut the springs!