pass1over
I like it LOW
I've about had it with this rattling from my rear suspension. Turn's out it was two different rattles, one of them I fixed, the other ...
The bushing's in my panhard bar were totally shot, so I replaced it and it solved that rattle.
I recently (last weekend) replaced the bushing on the top of the rear-end housing with a poly prothane unit. The stock rubber unit was totally worn out. I figured this was the cause of my sounds and replacing it would solve my problems. The rattle was totally gone for about a day or two, then it returned.
I hear it when going over bumps or it rattles like crazy when going down my rock/hard pan driveway. Everything's tight, i've checked it numerous times. When messing with the upper arm for the bushing install, the sounds it was making were very similar to what I hear when driving. I also hear the sound emanating from the center of the rear seat.
Did i just not get the bolt tight enough? Didn't check with a torque wrench, just got it tight as I could. Maybe the bushing on the chassis side of the upper arm is worn out?
Steeda adj. upper control arm w/ poly bushing, Steeda upper control arm mount, prothane housing bushing, Steeda billet lower control arms, J&M steel adjustable panhard.
The bushing's in my panhard bar were totally shot, so I replaced it and it solved that rattle.
I recently (last weekend) replaced the bushing on the top of the rear-end housing with a poly prothane unit. The stock rubber unit was totally worn out. I figured this was the cause of my sounds and replacing it would solve my problems. The rattle was totally gone for about a day or two, then it returned.
I hear it when going over bumps or it rattles like crazy when going down my rock/hard pan driveway. Everything's tight, i've checked it numerous times. When messing with the upper arm for the bushing install, the sounds it was making were very similar to what I hear when driving. I also hear the sound emanating from the center of the rear seat.
Did i just not get the bolt tight enough? Didn't check with a torque wrench, just got it tight as I could. Maybe the bushing on the chassis side of the upper arm is worn out?
Steeda adj. upper control arm w/ poly bushing, Steeda upper control arm mount, prothane housing bushing, Steeda billet lower control arms, J&M steel adjustable panhard.