don_w
Dyno Numbers - Who Cares?
I disassembled my entire dash last year to install gauges in the center vent panel. If I recall correctly, the side panels overlapped the center, which meant it all had to come out. I didn't have the PDF files for it (except the console ones), so I just had to figure it out as I went. And one important note, I had to remove the passenger airbag, which is a bit tricky. The PDF for that is attached.Thanks Hawgman! I missed that one about the individual vent/ "registers" completely.
Is the removal of the center and far right dash components done in the same manner as the "Instrument Cluster Finish Panel"?
i.e. Grab & Pull?
I'm pretty sure I didn't see mention of those parts specifically, but I didn't get much to eat today, nor sleep last night so I apologize if this seems redundant.
Is there a specific side (top, bottom, left, right) that one needs to grab first?
Thanks again! Nate.