Recent content by deathwishracer

Would you do $85 shipped on the strut mounts? If so, I'll take them.

One of the coolest swaps I have ever seen. Amazing work

Thanks for the info. So with this swap, I'm running a 1 wire alternator, which is charging everything fine, but the pcm doesn't have control of the alternator anymore. After some digging, it looks like the the 2 com & mon wires, communicate with pcm and regulator, and trigger error message...

Got my 408w installed and running in my 2010, got the factory ecu running all the gauges, everything including ac works perfect. 1 issue I have, I forgot to put voltage to the wire in the alternator plug for dash reference. So the voltmeter works, but it occasionally pops up with the check...

Even when you hold it down for 5-10 seconds, and it's supposed to be completely off, it can turn back on under extreme g forces. The only way to be certain it's all the way off is to pull the stability control fuse, #34. The yaw sensor and the lateral sensor are built into the RCM. I am going to...

Sold..

**SOLD**Magnum XL for sale with lots of upgrades. Fresh level 1 build from tick performance includes carbon blockers and bronze fork pads, $1700 build. Has Steeda tri-ax shifter, the shaft has been upgraded with 1350 joints on both ends with billet yoke. The standard kit has 1330 on 1 end, and a...

pm'd. I'll take them

Alot of 3v folks have had problems with Boundary, me included. But if you post that on the internet, the coyote Boundary nut swingers will say you are crazy. Pay up for TSS. Totally agree with sportinawoody

pm sent

PM sent

You can find the pigtails for 5 bucks on ebay, just run the wire to the brake switch

I did. I do have a simpler, cheaper kit for sale now. A zex box kit with nozzle, and purge.

pmed