Mustang is an important brand with millions of Loyal owners worldwide. No matter how good this new vehicle may be, using the Mustang brand is a BETRAYAL, and this uncaring action will be long-remembered along with the story behind the Probe.
What I meant to say was I may already have destroyed my resale value as a collectable Bullitt. It has a full exhaust, supercharger, cams, and 6-speed. It's now at 525HP to the wheels.
If I go to Auto, it may have to be built for the HP....
You'll always be chasing the weakest link. I have a Stage 2 E-Force and went ahead with forging the motor. So one day I was playing (showing off) and hit second gear hard. The tires hooked up...much to my surprise with stock tires.... but after that the 5-speed made whining noise in every...
I bought a 4-post. I'm a bit clumsy and I just know I'd be putting dents in my door with a 2-post. Also, the floor was already poured so I was worried that it wouldn't be thick or strong enough for a 2-post.
.
To me, the headlight-dimming at idle is a potential clue.
Check that the ground wire connections from the battery negative to both the engine and to the chassis are clean and tight.
.
Just for grins...
Dyno runs with B302, Kooks longtubes, high flow catted H, Edelbrock E-Force at 10 PSI, same camera.....
Borla Touring versus the KR mufflers.
Borla Touring
OfZcCaVH7EI
KR
rmQ-6YrK_0c
.
.
I have high-flow cats, and on the rear sensors I had to install 2 anti-foulers on bank 1, and 3 anti-foulers on bank 2, to prevent showing a code.
In my area, they check emissions without sniffing.
.
^^^ Good One! ^^^
.
One thing I've learned is that Ford combines Grounds from what seem like unrelated circuits into several common ground points. This can make troubleshooting a nightmare, because a loose ground can cause strange unrelated failures.
I was looking at a couple of wiring diagrams, and there are 1 or...