Recent content by Lcfrshadow

  1. Lcfrshadow

    Kenne bell tune

    Around how much, roughly, do you think getting a wideband and the install, will run me?
  2. Lcfrshadow

    Kenne bell tune

    I wish I could just chock it up to a learning lesson. Unfortunately, this is the only shop/tuner around, as far as I have been able to find. Getting frustrated
  3. Lcfrshadow

    Kenne bell tune

    This was a dyno tune by a local shop. He said that the area from 2750-3250 rpm was an area the he didn't want to spend much more time on. It isnt cost effective, to put it simply.
  4. Lcfrshadow

    Kenne bell tune

    Stock 4.6 3v Kenne Bell kit Spectre short filter Vmp 3 core heat exchanger w/dual fans After getting the Tune, the car doesn't feel as responsive as it did before. Throttle used to be snappy. Now, when I WOT it, there is a lag, kinda like too much fuel was dumped or a spark loss. The dyno chart...
  5. Lcfrshadow

    Loose sensor after Kenne Bell install

    I see. Yeah. Wont be mounting this thing in that location. Had to cut a lot out of the bumper when installing the vmp heat exchanger. Guess I'll just keep it tucked.
  6. Lcfrshadow

    Loose sensor after Kenne Bell install

    Really. Why is it threaded?
  7. Lcfrshadow

    Loose sensor after Kenne Bell install

    I found this sensor hanging under my front bumper. Its to the right of the heat exchanger. Any help identifying it would be greatly appreciated. 2010 Mustang Gt 4.6 3v Kenne Bell Supercharger VMP Heat exchanger(3 core)
  8. Lcfrshadow

    Kenne Bell 2.6 Install

    I guess I'll order it online. All the parts stores carry only one type, when I inquire about the sensor. Thanks Jump$. Punctual as usual.
  9. Lcfrshadow

    Kenne Bell 2.6 Install

    So what IAT sensor do we use. I go to the parts store and the only one they have isn't a threaded sensor. What year and model works for us?
  10. Lcfrshadow

    For all Want to buy threads. READ or your thread will be deleted!!

    I've read the rules, but can't figure out what the necessary required post limit is, for being allowed to post in the WTB section. I WTB!!!
  11. Lcfrshadow

    Wideband O2 question

    Looks like a PITA.
  12. Lcfrshadow

    Wideband O2 question

    No aftermarket exhaust. Everything is stock, exhaust wise. I haven't looked under the car, but how hard would it be to install the bung?
  13. Lcfrshadow

    Wideband O2 question

    I'm trying to get a tune on for my 4.6 3v now that it is supercharged. The tuner is telling me I need a wideband controller for him to tune it. (It is a remote tune being done) Can I just replace the left front O2 sensor with a wideband O2 sensor or do I have to add a new sensor into my exhaust...
  14. Lcfrshadow

    Kenne Bell 2.6 Install

    I think i have figured it out. 2 wires need to be cut from the maf. They are the maf IAT signal wires. These two wires need to be spliced into a connector to the IAT sensor on the intake manifold. Can anyone confirm this theory.

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top