Recent content by Slow50

  1. S

    Ac help

    Thank you everyone. It wound up being a few things. One was the ambient temperature sensor. The bezel, the buttons weren’t working properly so I changed it. And the blower motor resistor. I changed it 2 times with aftermarket parts. I ordered an oem FoMo and now it’s working. So if you get...
  2. S

    Ambient temperature sensor

    I did clear the codes, and it started working right away. The temperature was correct in the car. So of what I understand, I am not getting the signal from the buttons to the computer. If I press the recirculate/ fresh air button, It will light up and show it like it’s recirculating, but it’s...
  3. S

    Ambient temperature sensor

    Thank you for the help, No codes at all just the B10B9:14-0A. The buttons for the radio were not working properly so I bought a used bezel and module. I put them in, ran the codes again and still the same code. I swapped out to blower motor and two resistors still the same. I checked the...
  4. S

    Ac help

    B10B9:14-0A This code keeps coming up as blower control, but I swapped out two different blower motors, and resistors and no different
  5. S

    Ac help

    I put new HVAC and new bezel. The compressor does not kick on with the defrost thank you.
  6. S

    Ac help

    Sorry just seen this. Thank you for the help. so basically, the recirculate button lights up but is not working. With the scanner I can make it switch open and close. So I bought a used bezel and a used hvac module. Still no AC. The only code I’m getting now is B10B9:14-0A Blower control. When I...
  7. S

    Ambient temperature sensor

    Hello I need some help. I have a 2012 6cyl.My ac compressor is not kicking unless I jump it, when I do it’s ice cold. My ambient temp is showing 50 degrees, it’s 80 out. I changed the sensor,when I put it in I turned the key on and it said 78°. I started the car turned on the AC hoping the...
  8. S

    Ac help

    Thank you I need some help. I have a 2012 Mustang six cylinder and the air conditioner is not working. if I jump the compressor, it comes out ice cold. I hooked up my scanner and it's showing that the pressure switches are working. I took a screenshot of the scanner if it helps anybody...
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top