Recent content by Trevian26

  1. T

    Wont move in neutral

    Lifted up rear end again and tried to spin the rear tires and it budges like an inch or two forwards or backwards. Any guesses? Is it still differential or is it something else. Judging by the car stalling out when l let off the clutch in first is telling me, my transmission is at least...
  2. T

    Wont move in neutral

    Lifting up the rear end, both tires rotate same direction. When in neutral, with force I can rotate the wheels. Once I dropped the car, somehow once again I could roll the vehicle forwards and backwards in neutral. Then I tested what happened if i am on the clutch in first gear, and it then...
  3. T

    Wont move in neutral

    While I havent cracked open the differential, I have came across some new information that might be of help. I had to roll the stang while in neutral to slightly get it out the way for me to roll out my generator. In doing so, car off, hand brake down, in neutral, me and someone else managed to...
  4. T

    Wont move in neutral

    Im probably going to just do it myself. A few weeks after the job I had questioned the slight humming noise and the brushed it off as a “sounds like a tire or suspension issue” even though I stated it started happening after their work. Time and work isnt an issue for me, id honestly love to...
  5. T

    Wont move in neutral

    No they didn't and what sucks is they are the only shop within 30min that had a reasonable quote that wasn't thousands of dollars.
  6. T

    Wont move in neutral

    i was thinking of purchasing these if what is said is the issue. I already have the fluids in hand. Just curious if these two purchases would cover all the basis and if so can I reuse my gear set or do I need to buy that new too. https://www.americanmuscle.com/ford-31spline-88-carbondisc.html...
  7. T

    Wont move in neutral

    Another detail I forgot to mention (sorry). That whole incident happened on the attempt to go home from work. That morning to work however, I noticed that ONLY when I take on right hand curves the front end of the vehicle shakes, particularly the driver side. I do remember it had to be also...
  8. T

    Wont move in neutral

    Do I have any grounds to do so considering the installation was back in May? Im not opposed to doing the work myself and kind of worried they’d f up again
  9. T

    Wont move in neutral

    That’s honestly the route I was thinking. With it in neutral versus clutch in, I still got the same results at the time (aka no movement). The whining noise also seemed to slowly get louder over time. I want to crack the case open this weekend...
  10. T

    Wont move in neutral

    Yes I can throw the shifter into every gear. When I was moving it around in my driveway in first gear, I barely left off the clutch because it seemed like the more I let off of it, I can get a sense of strain/hear the the clunking noise start to happen and then obviously the car would stall out.
  11. T

    Wont move in neutral

    Hello, I drive a 2006 Mustang GT. A few months back I had a Ford Performance 3.73 gear kit installed by a shop onto my stang. I do a lot of driving (hwy/city) maybe two weeks in, I start to hear a slight whine coming from the rear portion of my vehicle. I heard it in all gears but obviously the...
  12. T

    P0300 Misfire

    A few weeks back the CEL came on for a p0301, I changed the spark plugs and cleared the code and it ran perfectly fine after. From then until yesterday no light.
  13. T

    P0300 Misfire

    The CEL never officially stayed on, this morning when leaving for work it started flashing for about 10sec as my RPM was increasing and I could feel the loss in power and it jerking and since I was in a hurry just turned it back around about .3 of a mile and drove my truck instead. As for my...
  14. T

    P0300 Misfire

    I installed an SR performance UD pulley yesterday.
  15. T

    P0300 Misfire

    I haven’t yet but was planning on using my voltammeter to check my alternator, saw somewhere that it could cause issues if its running to low.
Back
Top