Recent content by Vistablue3v

  1. V

    Need some guidance

    It does not disappear and just sits there!
  2. V

    Need some guidance

    Thanks for the guidance! I may just reach out to a professional just to see cuz tbh I really don’t wanna have to pull the motor and do that I’m kinda lazy
  3. V

    Need some guidance

    Do you think that piston would be fine? In your opinion?
  4. V

    Need some guidance

    Pretty sure incorrect install of the cams, most likely a rocker wasn’t seated properly, or potentially the phaser wasn’t seated 100% correct! To be honest not 100% how I could even figure out how the damaged was caused, any suggestions would be much appreciated!
  5. V

    Need some guidance

    Awesome thank you! What would be required in order to install stock gen 2/3 rods/pistons/rings are they a legitimate direct replacement for the stock 4.6l ones? Same bore?
  6. V

    Need some guidance

    This helps a lot, would you recommend just staying with the stock crankshaft as well? Also would you just pull the motor and do it or drop the oil pan and do it that way?
  7. V

    Need some guidance

    I was planning on installing Ford performance Hot Rod Cams, and a high output P1sc procharge kit, with upgraded blowoff valve, and an upgraded fuel pump! In the process of installing the Cams something went horribly wrong and I’m unsure what we did wrong since we followed all the instruction for...
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top