Recent content by xkillerxnatedog

Already tested he said only has 10 psi, an drops to 0 when trying to rev it, an dies out if you don't keep it to the floor.. An no the fuel pump filter is clean no debris not clogged it an yes i hear the fuel pump kick on as well..

So i just swapped motors out of my 2006 mustang gt an dropped a 2010 4.6 3v in because my motor sent a rod an dropped a piston.. So the car has sat for maybe 6 months now with a dead battery... Long story short after having my motor dropped in everything hooked up, it will start an run an die...

Lol i was just asking i wasn't sure about the 2v compared to the 3v but now i now..

Well what would have caused the plug to be smashed then... I figured it was from a dropped valve that came up an smashed the plug from the piston... Maybe if it warms up next couple days il pull the drivers side valve cover an inspect the springs an valves

I got a quick question for you guys is a 2011 crown vic 4.6 l 2v compatable with my 06 3v Mustang thinking about doing a swap but would like to use my cams longtube headers from my 3v an put them on the 2v?

Well when i changed the oil i didn't see any metal shavings or fragments in the oil so idk... Well keep you guys informed when i get the ball rolling

That's pretty much what im thinking on doing if i gotta tear the motor apart aslo he said, He would know more once the valve cover an head come off to see exactly what happened.. What all should i replace since most likely piston number 8 is gonna need replaced.. Would like to set the car up for...

So should i move forward with what he's suggesting he said im looking at about 1000 bucks in labor for him to pull the motor go through it an me replace the parts what needs fixed an throw it back together

So i had the compression test done, i didnt get the number but 1-4 had high compression, an oil was shooting out of the plug holes when we was cranking it over. cylinder number 8 had no compression at all he told me... So he believes that one of valve springs broke casuing my piston to come up...

Il be trying to do a compression test thursday... So what numbers should i be looking at in my cyclinders

I was just looking for help... Yea i plan on doing a compression test... I was just looking for advice.. Maybe hoping for the best.. Id rather rule out all the simple issue's it could be, before sinking money into rebuilding seals or piston rings an what not..

Really I've never seen it drip out.. Everytime ive ever had the cai intake tube off... Ive never seen oil come out the throttle body this is a first for me to see that... So sounds like im going nowhere...

Gottcha that makes sense but just found oil on the outside of my throttle body going into my cai tube..

So here is another tip.. Just pulled off my cai an tube an there is oil on the outside of my throttle body coming from my intake..