Search results for query: *

Carbon Creations

My carbon fiber says 25lbs

I stay with all OEM ford parts for sensor/actuators, otherwise you become a great mechanic replacing aftermarket parts. I also have the FFRP twin trottle body 2.5 years with no problem.

I also have a carbon fiber hood going on, the Redlines look like the way to go. Carbon fiber are lighter than fiberglass, struts with less PSI are needed. Fiberglass uses heavier struts. Too much PSI will fold the hood like and older chevt truck hood.

Make sure warranty is good for as long as you own ev, batteries are expensive

I did the MC front coil overs, originally had 550lb springs. It rode like a brick but may have been good on the track. Dropped to 350lbs spring and car rode much better. 350lbs front 250 rear on mine. Rides good and handles well. I also have all new suspension, new Gt 500 front (harder bushings)...

Would slowing it down with under drive pulleys help ?

e3's melted in my car. Go brisk

My 373 are quiet, only 10k on them.

I wasn't talking trans am

Any hole in a hood will either let air in or out. A reversed scoop would work like a vent with a cover. Of course heat extractor hood would work better.

Tranny shouldn't need a refresh at 48k, of course original owner could have damaged it by being stupid

Looking for a hood for my 05, hard choices. Stalker hood looks the best. Spending all the money for hood and paint I would go with something that removes heat.

Cali sucks

Both my 05's and my son's 2012 axles were shifted towards drivers side when wider tires added

Same wheels I run 18x9/18x10 AMRs

If its been vibrating that bad it needs to be fixed ASAP, my mechanic checked my 410 gears(installed before I bought car). He didn't let car leave until it was right. He redid gears (373s) and problem was gone.

I would disconnect drive shaft at diff as suggested, would narrow it down to either tranny or diff.

Not sure on cost, but a lot of the car shows use them. Iron Resurection only uses them on their builds

Have you looked at Budniks

Is your axle centered ?

What are you running for shocks, are they doing any dampening at all

Great write up, I have a #1 on my counter.

That sucks, hate to see cars/trucks rust like that

Actually the whole job looks great