Search results for query: *

  1. T

    Fuel gauge

    I’m installing an aftermarket fuel gauge in my car and was wondering if anyone had done this? From my research it looks like each sender will have to be connected separately (going to run them to a rocker switch and 1 gauge) The blue/yel wire is grounded so the yellow(passenger side) and...
  2. T

    Battery light?

    I will test it after I get the car put back together. I was just thinking someone may have know which wire it was.
  3. T

    Battery light?

    I found it on a google search. I’d rather not have anymore gauges. I just need to know the light went out so it’s charging. The pinout I found of the cluster looked like the battery light ran through the canbus wire. I was hoping to run a wire to the engine bay from the light and bypass the...
  4. T

    Battery light?

    Anyone??
  5. T

    Battery light?

    Does anyone know which wire I need to tap into to get a dummy/battery light to work. I’m swapping a big block into the car and ended up not using the factory cluster and I have a red led I was going to use instead of installing a gauge. If I’m thinking right I should be able to run it off of pin...
  6. T

    Timing questions

    I have an 06 4.0 and an HP tuner that I’m using to learn computer tuning. I was wondering how much timing these engines liked? It doesn’t seem to effect total timing no matter what I do it stays around 24-25°. I have upped the MBT tables and still only getting the 25°. When scanning the car it...
  7. T

    Nitrous

    I’ll start by saying I’m totally new to nitrous. I traded for a couple kits so I have almost everything I need to add it to the 4.0. My question is how much are you running and what else have you done. I have HP tuner so I can play with fuel and timing some. What are some do’s and do not’s.
  8. T

    5R55s strength?

    I’d like an overdrive so I could continue to drive the car as much as I do. Yes there are several adapters available to bolt a 460 to a Mod transmission. I was going to build one.
  9. T

    5R55s strength?

    I currently building a 460 to put into my 2006 v6 car. I was wondering how strong the transmissions are. Will they hold up to a 500hp big block. It will be mostly street driven with the occasional drag day. I really like the idea of the 5 spd behind the 460 but would be a lot of work for it to...
  10. T

    4.0 to 3.7 V6 swap

    Congratulations on all your hard work. It’s always a good feeling when a project reaches the finish line.
  11. T

    Subframe connectors?

    I see that they are sold to fit the 05-09 cars but never see anyone recommend adding them. Are they needed or are they a thing of the past?
  12. T

    4.0 hits a wall

    I tried to get my scan gauge to read fuel pressure but so far have been able too. I also can’t find anywhere to connect my gauge to check it. I did change the one under the car. The fuel pump duty cycle seems to stay down like it’s not struggling to keep up but would like to be able to see the...
  13. T

    4.0 hits a wall

    I’ve been working on getting this 4.0 running right. It runs strong until about 4500 and then seems like it hits a wall. You can back out of it so it shifts and it will pull hard until 4500 again. It does surge some after 4500 like it is starving for fuel. I can hook my scan gauge to it and...
  14. T

    What have you done to your mustang today?

    Ordered 5 injectors after only changing 1 last week. And ordered a leather steering wheel cover that stitches together. We will see how it works.
  15. T

    4.0 cold start issues.

    Under the throttle body in the thermostat housing
  16. T

    4.0 cold start issues.

    FIXED!!!! I remembered last night that my scan gauge would read the water temp. Went out this morning 28° outside. Gauge showed 130° ran to the parts store installed new ECT and it then showed 28° and fired right up.
  17. T

    Making a 2010 road worthy again... worth it?

    So it sounds like you need a new transmission and you have some wiring issues. I would say the biggest question is how much work can you do yourself and how much will you have to pay a shop to do. Do you need the car running quick to replace your car that was wrecked? If so I would suggest...
  18. T

    4.0 cold start issues.

    What I’ve read is that the ECT sensor is messed up and not telling the EFI that the “choke” need to be on to start when it’s that cold. But no one posted that they got theirs fixed.
  19. T

    4.0 cold start issues.

    So I just bought this car and I’m working through all the issues getting it all lined out. If the temp is below about 40° outside the car is extremely hard to start. After some googling it seems the ECT sensor is the most common suggestion but there’s never any post telling what fixed the...

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top