Search results for query: *

Car is a 14 gt tvs (9 lbs) 6r80. Has had this problem as long as I can remember. If I rev the engine while in neutral it sounds very labored. While decelerating it will hunt for idle. At part throttle it has a definite surge. No matter what I do it shifts 1 to 2 at or below 6500 rpms at the...

So my friend was getting his car retuned. He wanted me to drive it since our cars are similar. Long story short, smoke screen, clunk clunk. Car has a tvs at 10 psi. Made 720 rwhp on race fuel at 13psi. So who has good deals on forged shortblocks?

So I have this headache often when launching at the track. Car is at operating temp, half tank of fuel, traction control is totally off and the car is not spinning. When I launch it feels like it is pulling timing. There is absolutely no tire spin and as soon as I shift to 2nd its fine. It is so...

Previous dyno was 433 rwhp with jpc longtubes, hushpower catback, steeda cold air and jpc tune. Finally got it dynoed with the roush tvs with jlt cold air, 82mm pulley and the above parts. I was hoping for high 500's. i was very pleased to see it put down 652 rwhp. Gotta thank Ken bjonnes for...

Not sure who has experienced this. Has happened to me a few times and was happening to a friend alot this past test and tune. With the traction control completely off and getting a decent launch it feels like the traction control comes on and pulls timing or something. The car has no power...

Went for a drive tonight to the local car show. Only drove a total of about 5 miles. Noticed slight clutch chatter when pulling from a stop. I also notice a slight vibration in the shifter. Time for a new clutch or anyone think its something more serious? Stock clutch with about 4800 miles and...

Got my car out to the track last night. Feel that I did ok with it being the first time out with the roush tvs on. Car has Out of the box roush tvs with 82mm pulley (around 8psi) Lund tune (Kenb), jpc long tubes, hushpower cat back, 3.73, upr upper and lower control arms and 27x10.5 et...

Looking for copper core spark plugs. Anyone know the part number for NGK for coyotes? Preferably for fi application. Auto parts stores have nothing listed besides iridium and platinum.

In the page i am showing. Where is the passenger side radio capacitor? I have no idea what or where they are talking about. Anyone with experience point me in the right direction? A picture of what and where they are talking about would help if possible.

I need to purchase a boost and AFR gauge along with a wide band O2. What are you guys using? Put up a pic if you have one please as well as the price you paid and where purchased.

Dont think its a repost. Not mine just found it while trolling youtube. ENJOY

2006 CBR1000rr, 67xx miles, PC3 USB, proton flushmount front turnsignals, integrated rear turn signals, jardine slipon, spike wind screen bolts, new battery , tires with 75% tread. Owned by a car guy so you know its taken care of. I have owned this bike since new. Oil changed every 1500 miles...

Was going through my camera and decided to put up the video that I could find from 2011. If you go to PRP you might be on here. I apologize for my friend recording some of the runs. He shakes the camera alot. Video

Made the trip (3.5 hours) to JPC Racing for a little dyno action today. Justin and his crew are great guys. From what I saw the car picked up 20 hp over the steeda tune. Final was 433hp and 400 tq. I'm happy with that. Quite a difference from a H/C/I foxbody that made 299rwhp 15 years...

So let me start from the beginning. I took my car in for the hard shifting tsb. They told me my car exhibited the hard shifting and changed the fluid. Not much different afterwards if you ask me. So called them up and took it back in for hard shifting again. They kept my car for 2 days, called...

So I got my jpc longtubes on. PITA but if feels good on the butt meter. This thing is extremely loud. My exhaust consists of the longtubes and hushpower cat back. The hushpower is 3". I need some resonators and was wondering if anyone ran these or has any experience with them. resonator

Anyone have any tips, tricks or hints, aside from using a lift. I will be doing it on jackstands and hope to do it without dropping the k member. Will be putting JPC longtubes on a 2011 gt.

I purchased a set of longtube headers a few weeks ago. Due to it being cold and not having a heated garage I havent installed them yet. So i look at them alot and found a big glob of metal from a weld. Right beside the glob there is a divot in the metal. Should I just get them fixed up...

Just saw this on autoblog. http://youtu.be/k9hEJHhw9hA

Santa is starting early for me this year. He's really generous to me this year. Hope I see 4 tenths reduction in et from these.

For anyone that has their rear o2's turned off in the tune. Is there any negative effects at all, gas mileage, drivability, etc....

Is anyone running off road down pipes (section of pipe containing the converters between the headers and midpipe)? I have only found them produced by hearthrob. Does anyone else make them? Does anyone have a link to a website that sells them? I cant find a website that actually has them listed...

Hello all. Been trolling for awhile but, havent posted yet so here is my first. After learning to launch on et streets pulled an 11.98 @ 115.38mph with a 1.69 60'. Backed it up with an 11.99 @ 115.47mph with a 1.67 60'. 2011 gt, 3.73, 6m, steeda cai, steeda tune, hushpower exhuast, upr control...