gears

  1. Racer45

    Swapping final drive gears In automatic trans cars?.

    So I just recently installed comp cams 127400s and there great and have been an absolute game changer for me on track especially being able to run the RPMs up to 7350. Only down side is I greatly underestimated how much toque I’d loose down low. I tried tossing in a aluminum drive shaft a few...
  2. R

    07 GT droning from rear end

    Hey all, Have been getting a low droning from the rear end for months now. Only starts at about 50mph. 07 GT 102k I had assumed it was the axle bearings so I took some time this past weekend to swap them out, but the sound continues albeit maybe not as intense. I put 75-140 in the diff...
  3. Andrey Sidorov

    m340hv pump, same gears as oem?

    Hey lads, doing a whole timing job on the motor now, as well as new lash adjusters and roller followers, i have a set of new billet gears coming in from boundry , anyone knows if m340hv pump from melling shares same gears with oem pump? PS. Post is comming soon on why you have to do research on...
  4. V

    Pinion hits carrier, but reads deep

    I have a Ford 8.8 axle and am trying to install a 3.73 US Gear ring and pinion. I’ve put it together about a million times and can’t get it right. Most recently: after doing the pinion measurements using a pinion depth setting tool and installing what I determined to be the correct pinion shim...
  5. Shredder

    Selecting the Right Gear Ratio - Need Help 5.0 A6

    Hi All - Probably should have joined awhile ago. Been pretty content reading rather than posting til now when I’m on the fence. Looking for some input from user who have a similar setup and/or Auto. I got a 2013 GT Convertible that I mainly putz around in. Currently has the 6R80 and 3.15...

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top