GT500 and CA Special Fascia Install Question

[Kona5.0]

Just got my fascias in today - no push pins or hardware included - do I re-use what's there only or do I need to make a run to the dealer for some parts?

 

[Kona6Stang10]

for the CS front you should be able to reuse your hardware.

GT500 rear? or front....
if front...you'll need a lot of stuff.

if rear, I just reused everything.

there are two little tab things that I didn't have hardware for...but some thick black pushpins oughtta do the trick....they mount behind the actual bumper support.

 

[302]

The CS front is a direct replacement of the bottom plastic part. No push pins required. Just snap it out, and snap it in back in.

 

[Kona5.0]

Cool - thanks guys - CA Special front and GT500 rear - should look nice. How long did it take you guys, and I'm assuming both front & rear bumpers gotta come off? I'm still at work, haven't had a chance to actually look at it yet.

 

[captdistraction]

you can do it with the rear bumper on the car, but its not going to be friendly on your fingers.

 

[Kona5.0]

I noticed my buddy's GT500 axle back seems to be tucked in/stick out less on the stock GT fascia, so does this mean that my hushpower axle back (that sticks out a lot further than the GT500) is going to be sticking out awkward-like? Anybody have an issue like this?

 

[302]

you can do it with the rear bumper on the car, but its not going to be friendly on your fingers.

Hindsight you probably can, but it was not too hard removing the rear bumper to make it easy on yourself.