Can anyone look at my sct livelink idle log? specially the idle1 log. My stft on bank 2 goes haywire for some odd reason and causing my car to run very rich for a couple of seconds and return to normal. I have a wideband O2 also and when it happens my afr drops to 10.xx and goes back up. It...
Got your evap to "ready" state? I followed the Ford procedure also and got evap ready, got freakin lucky! it took me a couple of days to get that damn thing ready the last time I went. I just got my catalyst monitor ready and taking the car in for inspection tomorrow, all monitors are in ready...
Check your return line to the pan, might be kinked or pinched not allowing for oil to properly drain back to the pan. Worth a shot but most likely a seal issue.
I recently added 2 of these http://www.ebay.com/itm/2-5-x-18-Long-Vibrant-Performance-Exhaust-Resonator-Stainless-Steel-1793-/310767570550?pt=Motors_Car_Truck_Parts_Accessories&hash=item485b30ce76&vxp=mtr to get rid of my exhaust drone after replacing my offroad h with an x. So far, its doing a...
BruceH, like the op I have the same paxton air to air setup with 2 bpv and going blow through. One underneath the elbow next to the throttle body and the other bpv on the discharge tube of the supercharger. The bpv next to the throttle body can be deleted correct? and I can just put a bpv/bov...
Squeak fixed and gone! that bolt is a pita, soaked it with pb blaster for a couple of days and it would only turn a hair and then stop. Ordered some kano kroil which I got today and put 5 drops around the bolt then waited 10 mins and the bolt came right out! :beerchug2:
Congrats! I started with a non cooled vortech and called up brenspeed to see if they can hook me up with an air to air intercooler kit and got a good deal so I went for it. That was 3yrs ago lol. I have no issues with my centri, pita to change the serpentine belt though.
Definitely from the block, I'm thinking maybe there's some rust inside the block where the bolt goes through the shaft making it squeak when it moves. You think it will be alright if I put some flame on the block to loosen the top bolt? that bolt is pretty tight when I tried loosening it.
I took my shifter assembly out and also disconnected the shift linkage from the trans. Its definitely coming from the block with the bolt on top. I smeared some lube around the shaft where it hooks into and wiggled the block side to side hoping to get some grease in there, still squeaks. I...