Search results for query: *

Check link http://mustangsdaily.com/blog/2014/03/27/ruby-red-2015-ford-mustang-gt-spotted-filming-tv-commercial-in-utah/

I'm personally disappointed in the styling. Enjoy. http://www.autoblog.com/2013/12/05/2015-ford-mustang-official-photos-reveal-info/#continued

Went to track yesterday. Made 4 passes, everything fine (ran Tune "A"). Before last pass (#5) I must have left intercooler on too long & battery died. Had an aquantance jump it with his truck, then went to lanes about 15 minutes later (decided to load Tune "B" for last run). Went to do normal 5...

Everybody with an automatic & a line lock. What rpm's are you releasing the line lock switch with your burnouts?

I have the 3.5" Whipple pulley for 10#'s of boost on HO kit. Want to change pulley to either a 3.25" (11-12#'s) or 3.125" (12-13#). Belt setup is unchanged from original Whipple install except I have upgraded to Thumpr tensioner. My question is can I just change to smaller pullies & use same...

Chain of events: car runs 11.1-11.27 @ 122, 1.57-1.62 60' late fall after updated tune, 6pt. rollbar installed (offset 90# by race seat, deleting rear seat, BMR K-member, A-arms & radiator support delete), the next spring run car on street for a month with no issues, then early spring 4 passes @...

I have OEM V6 front struts & rear springs in my GT for weight transfer @ track, along with mods in signature. I drive on the street during nice weather. Looking to upgrade shocks & possibly struts & springs. What's everybody running for setups.

Can someone with a 06 Mustang GT confirm there car does or does not do the following: Put key in ignition & turn to on (don't start), watch most of the dash symbols go out. The oil & engine light remain on & after 12 seconds the engine light flashes 7 times then goes back to staying lit, oil...

Just got car back from doing a compression & cylinder leak down test. Results are as follows: Compression: 1=204, 2=200, 3=196, 4=206, 5=190, 6=184, 7=200, 8=193 (all within 10%). Cylinder leak down test: 1=8%, 2=4%, 3=4%, 4=2%, 5=13%, 6=3%, 7=4%, 8=7%. Tests were done on cold engine, they had...

Recently had JLT oil separator installed. It's been 1,252 miles (including 3 - 1/4 mile track days, 12 passes total), rest was 85% highway miles. It had 3/4" of oil in separator. Isn't that unusually high in just that many miles?

What would cause car to perform the same way with T/C on or off? Stang has felt slower, like its spinning ever since I've installed 6pt. roll bar. Previous tune car ran strong, next season after roll bar, felt slower. Recently got a new tune(different place) & same thing. Both tunes T/C is on...

I'm taking my car in next week to have a new belt, thump-rrr tensioner installed & a leak down & compression test done. I've been chasing a power loss for over a year now. I'm not mechanically inclined, thinking it might be a bad ground somewhere. What grounds should I have checked out while car...

Just traveled to & from Brenspeed, 9hrs. each way(1,200 miles total) on Monday, April 22nd. Had a new Performance Automatic 5R555 Super Streeter trannny, Shaftmasters D/S, Circle D converter & a few other minor things installed. Every employee I met was courteous & knowledgeable, answering any...

Just traveled to & from Brenspeed, 9hrs. each way(1,200 miles total) on Monday, April 22nd. Had a new Performance Automatic 5R555 Super Streeter trannny, Shaftmasters D/S, Circle D converter & a few other minor things installed. Every employee I met was courteous & knowledgeable, answering any...

Im going to be installing my JLT oil separator in spring. I know that it's not plug-n-play so I ordered just the separator, no fittings. I don't have immediate access to my car because it's in storage. I need to know from other 05'-09' Whipple owners with JLT seperators exactly what I need to...

I need to have the following installed: Performance Automatic Super Streeter transmission(upgraded internals, hardened input shaft), Circle D 3,200rpm converter, Shaftmasters driveshaft & BMR safety loop. My current automatic trans. is showing wear & tear. My dilemma is where to get the above...

This April I will be having my Performance Automatic Super Streeter 5R55S transmission, Shaftmasters D/S, Circle D 3k converter(Stage 3, 245mm 2B) & a JDM transmission catch can installed by JDM. I need your guys feedback on what I can add or do to keep transmission temps down for longevity. I...

Are the Ford Racing spark plugs that came with the Whipple HO kit a 1 or 2 piece design? How often should they be changed, nothing in Whipple manual about frequency.

Need suggestions on what steps to take on getting my 5R55S fixed. Car still drives OK on street but @ track I'm losing ET & MPH. No more passes @ track till I get tranny fixed. Lasted 15k & over 130 1/4 mile passes since S/C installed. Who to use or not use to get it get it rebuilt stronger? Do...

Has anyone ever tried this? Does it help with launching? Went to a track event & saw that in the trunk they mounted a metal bar across trunk with 2 vertical tubes(one on each side of car) with lifting weights attached. Is this like moving the battery to the trunk, except more weight above the...

On both my track & street tires I've noticed that the rear P/S tire is wearing more on the outside of the tire. Plan on taking it in to shop for further investigation but I want your guys input as to what could be causing this to happen.

I think my 06' OEM battery is on it's last leg. 6yrs. & 23k miles. I am aware of the Shaker 500 drain & always turn off radio before turning off car. Alternator is OK. Car sat for 3 days, charged it, then died 2 days later, no driving. Have been looking into an Optima battery for replacement. I...

Very soon I'll be replacing my Whipple H/E with the Afco w/10" dual spa fans. Is it necessary to get an updated tune? I'm sure my IAT's will be going down with new H/E, so less timing being pulled, therefore more HP, correct? Does the computer pull timing independent from the tune, therefore no...

Will be buying an Afco 07'-10' GT500 dual pass heat exchanger w/dual 10" fans to upgrade from the Fluidyne one that came with my Whipple. I've seen on a few website that it will fit 05'-09' GT's as well. Who has bought & installed on a GT & what modifications need to be done? My shop will be...

My next mods will be an aftermarket torque converter & single aluminum piece driveshaft (Shaftmasters) with safety loop (BMR). Looking to purchase during this holiday season. For the converter I need to know what brand & flash-stall speed to get. Have been leaning towards Precision Industries...