Another motor mount question

[tom281]

Mounts are on their way!

 

[tom281]

Installed the mounts last week..... they did indeed raise the engine by about 1/4". I had a spacer in my shaker that raised it about 1/4"- I had to remove the spacer in order for the hood to close without smashing the surrounding fascia.

Just FYI to anyone with a shaker setup.

 

[SC boss]

Installed the mounts last week..... they did indeed raise the engine by about 1/4". I had a spacer in my shaker that raised it about 1/4"- I had to remove the spacer in order for the hood to close without smashing the surrounding fascia.

Just FYI to anyone with a shaker setup.

Wich mounts did you end up going with that raised the engine? I dont know if I can deal with a 1/4" increase, I had pipeing rubbing with the stock mounts! Thanks

 

[tom281]

I did the Prothane mounts as suggested earlier in this thread..... I like the mounts, they turned out well. I was worried about my Vortech/Paxton setup, but it was OK- only the shaker needed some work and it probably wouldn't have needed it if I didn't already have it raised up a little bit.