California Special side scoops install

[merlinv]

Hi,everbody.
Does anybody on here have the California Special side scoop templates for the RH /LH scoops. I need a set of templates on where to drill the holes. let me know, Thanks

 

[TGR96]

I installed mine with 3M two sided tape. I'd definitely try to avoid drilling holes in your car if at all possible. The 3m tape is no joke. 'Dem scoops feel like the were cemented on!

 

[Scott_0]

there are no holes needed, as said, they are attached with 3M tape, when I removed mine, which came as part of the "appearance package" they were attached with the 3M tape only

sent from my S6 using tapatalk

 

[MassMustang]

Same here. Mine are attached with 3M tape.

Make sure you clean the surface first and remove any wax. Then, just expose a tiny bit of the 3M tape on the corners and leave a tab of the red peel-away strip sticking out to allow you to line things up properly. Once lined up, remove the remainder of the red strip and press. That sucker won't come off!

 

[UltraKla$$ic]

I passed out at "drill the holes".......

 

[07TR]

I passed out at "drill the holes".......

Lmfao I read this and was gonna say you wanna make sure you know a good painter for the mess this is going to create but then I believed this guy couldn't be serious

 

[travelers]

Don't forget the adhesive promoter it really helps

 

[Pentalab]

Don't forget the adhesive promoter it really helps

this

 

[Mustang Mark]

Don't drill holes, just use a BFH and hammer some nails into the body. One in each corner of the scoop should do the trick.

 

[BleedinBlue]

Duct tape and super glue > all of your dumb ideas.

 

[MassMustang]

Duct tape does fix most anything!

 

[MADGT]

Use the 3M tape...dont drill holes...them things aren't going anywhere...trust me.

 

[AndrewS197]

You were gonna drill into the side of your car?!?!?

 

[07TR]

Darren he is trying to learn the ways of darrenism teach him

 

[07 Boss]

You were gonna drill into the side of your car?!?!?

The install instructions say to drill holes. Are they necessary? No. But it wouldn't be out of line to drill especially if they tell you to.

 

[merlinv]

Well I found the original instructions and it sez to drill two holes and insert some specisl grommets that the scoops come with for the plastic studs

 

[05stroker]

Well I found the original instructions and it sez to drill two holes and insert some specisl grommets that the scoops come with for the plastic studs

For the side scoops or the hood scoop? No way I would drill my quarter panel.

 

[07TR]

Do not and I repeat do not drill the rear quarter panels on your car

 

[TGR96]

^^^^THIS X1,000,000,000!

USE 3M DOUBLE SIDED TAPE. THEY WILL NOT GO ANYWHERE! Trust me.

 

[BleedinBlue]

Do not and I repeat do not replace "says" with "sez"

FTFY





The vinyl wrap shop removed my side scoops, wrapped the car, and taped my scoops back on. I'm very OK with that. Tape. Them.