sdleo29
forum member
I know the spec is 30 ft/lbs + 90* , they are TTY, so one shot deal on the bolts , but I feel like I am going to snap these bolts getting to +90 . How hard should I expect to be pulling on these to get to +90?
I really didn't want to take all of my followers back out and the chains off to mount the phaser locking tool to the block, but do I have to? Should I have pre lubed the bolt? I am so scared I am going to snap the bolts... I am at ~ 45-60* and anymore I would need a big ass breaker bar and have to hold the crank from moving.
Any suggestions? It just doesn't feel right. The cams are custom grinds from L&M which come from Comp. Could they have fucked up the tap on the cam?
Something so easy is driving me crazy
This is the first time obviously cranking down on these bolts has me scared to death... lol
I really didn't want to take all of my followers back out and the chains off to mount the phaser locking tool to the block, but do I have to? Should I have pre lubed the bolt? I am so scared I am going to snap the bolts... I am at ~ 45-60* and anymore I would need a big ass breaker bar and have to hold the crank from moving.
Any suggestions? It just doesn't feel right. The cams are custom grinds from L&M which come from Comp. Could they have fucked up the tap on the cam?
Something so easy is driving me crazy
This is the first time obviously cranking down on these bolts has me scared to death... lol
Last edited: