Recent content by Apharaoh06

  1. A

    Official APEX Wheels Showroom Gallery Thread

    I saw how they hit the caliper, so the installers put back on my original EC-7s. I was frustrated when they showed me they were hitting the calipers. And they quickly put my original EC-7s on my car. When I was able to get in touch with you, was after the fact. And I was not going to wait to...
  2. A

    Official APEX Wheels Showroom Gallery Thread

    I just purchased a set of 18 x 10" VS5-RS for my 2007 GT500. Wheels hit my stock front calipers. I am currently running the Apex 18 x 10" EC-7 with no issues. Quality control needs to be checked on these wheels. At around $800 + a wheel retail or direct with shipping, this is not cool.
  3. A

    Camber Plate / Suspension upgrade advice needed

    Adjustable Panhard bar depends on your car. I needed one because my rear end was not centered due to lowering. But every car is different. Some may need and some may not. A square setup will help in the understeer department, and most stock mustangs are square to begin with. Usually the...
  4. A

    Camber Plate / Suspension upgrade advice needed

    Maximum motorsports is the go to Caster/camber plates. I have them and am lowered 1 inch on pedder springs. I purchased my car with the Ford Racing lowering kit and K springs. Too much bounce on my roads, and scrapping all over the city. Was tight and low body roll. Currently on pedder...
  5. A

    Rear anti roll bar

    It looks like a Granatelli bar or Hellwig bar.
  6. A

    Kooks exhaust

    I purchased my car with the Kooks already installed and Magnaflow exhaust. It is stock no tune, but has a tuner. Mechanic tested and all running in normal parameters. I had a damaged catalytic converter, so I replaced it with the Kooks green catted. Still same results over a year no codes and...
  7. A

    Kooks exhaust

    I have a 2007 Gt with Kooks long tubes and green catted x pipe. I am currently running a Magnaflow street exhaust. I do not have any drone. I am looking to replace it with the Kooks cutback, and am wondering if anyone out there has this complete Kooks exhaust. Does it Drone?
  8. A

    Thoughts on This Suspension - 2007 Mustang GT

    I have a 2007 GT I bought las summer, with low miles. I went with Bilstein struts and shocks, not adjustable but monotone construction. I like the monotone for more consistency if you are going to be doing driving that may cause your struts and shots to heat up. Spring I went with 1" Pedders...
  9. A

    WTB: Parts List!

    I have a 07 GT grille, off a 10,000 mile garaged car. Cheap. Its in superb condition. PM me. Also have some Apex EC-7 18x9.5 wheels with less then 1000 miles on them (only two wheels). Steeda front sway bar end links, like new, no box.
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Sponsor Links

Banner image
Back
Top