Words cannot explain how AMAZING and FLAWLESS my car looks after Jonathan got done with it! Not only does he know what he is doing, but he is extremely easy going and has such amazing customer service. Hell , he even came with me to a car show to make sure the car was in tip top shape!
For...
I know Kaden personally and he is a great person. Yes he is 17 and made some mistakes, but who the hell hasn’t? Everyone gives him shit about having a badass car at that age, EVERY single one of us wish we could have that given to us. Instead of you guys bashing him, how about trying to pass...
I am very interested in darkstars, 15 for the rear and 17 for the front to fit the gt500 brakes i have. Do you have that available? i am at work and cant read the thread to see what is left. thanks
Ok thanks for the info guys, i didnt really think about the teflon tape. The valve came with a gasket in place at the base of the plug, do you think that will be enough to seal it properly? Or should i just remove the teflon tape so it doesnt break down and possibly mix into the oil?
No leaks yet, i made sure to wrap the valve with some teflon tape to ensure the seal was good. Its going to save quite a bit of time going forward, and save a lot of mess.
Is the cross over for 05-06 mustangs? Do you know if they would fit an 08 without major problems? I have an 08 with a saleen blower (so i have the 05-06 coolant hose assembly). I would rather switch cross overs than buy all the coolant hoses again
Sorry for the delay guys! I tried the prying/pulling method with a couple of friends, we could not get it out all the way without some serious crossthreading. Then, my older friend Steve came over (55 , I am 25) to save the day. He got the bolt out in less than 5 minutes!!!!! He said his 40...
Ok i will definitely give this a try. I will use the vice grips to hold the head of the bolt tight, and then pry the bolt out on both ends so that there is even force and i dont strip it more.
I looked up how expensive and labor intensive it is to swap pans, I REALLY hope the pan is not...
After a month of trying to schedule a retune (tomorrow), I decided to change out the oil to get a fresh set for the dyno tune. At the same time, I was going to install a drain valve so that I never have to remove/reinstall the drain plug.
Anyways, when I was backing the bolt out, I...