Recent content by Cheeser

  1. Cheeser

    Ford Racing aluminum axle cover fit?

    Been a while since I installed, but don't remember any issue with the supplied hardware. The lubelocker gasket has not leaked.
  2. Cheeser

    Ford Racing aluminum axle cover fit?

    Yes, put one on my 2013 GT back in 2014. If I remember correctly, I had to disconnect one end of the panhard bar to remove the old and install the new. I also used the lubelocker gasket so I didn't have to mess with silicone and allowed me to remove/reinstall without scraping the old gasket...
  3. Cheeser

    Alignment...can’t meet stock spec with MM CC plates

    Yep...have the specs. Verified they were installed correctly...notches on the plates to the outside of the car.
  4. Mustang Alignment After Lower

    Mustang Alignment After Lower

    • Cheeser
    • Media item
    • Comments: 0
    • Category: Example Category
  5. Cheeser

    Alignment...can’t meet stock spec with MM CC plates

    Based on what I have read here and other spots, looks like -1.4 should be fine...will just monitor tire wear. I will increase the negative to -2.5 or so for an actual autox event. Socaldoug….I can go more negative....that's not the problem. I just go any more positive than -1.4.
  6. Cheeser

    Alignment...can’t meet stock spec with MM CC plates

    Finished the Koni/Eibach/MM CC plate install this weekend and took it to an alignment shop today, along with the instructions. In performing the alignment, the tech couldn't get either side to meet the stock spec of appox -0.7....couldn't get any more positive than -1.4 on either side. Curious...
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top