Recent content by coyote5.0

I'll take the gear kit. PM sent.

I need a set of rears how much $.

Mine were the same on initial install, loosen all bolts and pry engine towards drivers side and retighten bolts. Have not had any issues for two years now.:2cents:

I'll offer $300.00 for the X-pipe .

I used a test light at the ignition wiring harness till I found the 12V switched circuit. I don't remember the color sorry.

This is from the aeroforce web site

3.5 Bar Map Sensor Kit Instructions Part # Sens022 The 3.5 bar MAP (manifold air pressure) sensor measures air pressure from vacuum up to 35 psig. Connect the red wire to switched (ignition on, also known as ACC) +12v, the black to ground, and white to one of the Interceptor scan gauge’s...

I think your incorrect about the 5 volts I followed the instructions that came with my aeroforce MAP sensor 3.5 bar and used the 12V switched and works fine.

The 3.5 Bar MAP sensor part # sens022 uses a switched 12 volt also known as ACC. to the red wire.

Need price on dual aeroforce gauges, 3.5 map sensor and dual sos pillar pod shipped to 12020. Thanks

I'll take it just shoot me a total shipped to 12020 and your pay-pal paddress. Thanks

Count me in please.:clap: Thanks

I installed the JPC headers, off road X pipe and intermediate pipes with my GT500 mufflers and love it, did the install myself. Excellent fit and quailty also service is second to none !!

Hello Tim, I would like to talk to you about your Whipple if you dont mind. If you let me know your phone # or my # is (518) 885-3037. Thanks, Ed

Hello Tim, How do you like your whipple and if you don't mind who did you purchase it from and how much $. Thanks, Ed