Recent content by Daddidio

  1. D

    Water intrusion

    I have remediated my problem with water ingress to the cabin, cleaned the SJB so it works again (whew, lucky) and am installing the windshied wiper cowl grille pieces. The pieces are a bit warped and not sealing well against the windshield. The rubber strip is integrated into the plastic and...
  2. D

    In search of 2005 SJB fuse box

    Need to find compatible cowel retainer clips (that fit on the windshield side) the metal clips that you attach to the plastic ones on the cowel pieces before you press them into the rectangular grommets. I can can find the grommets (don't need them) but not the clips. Has anyone used a...
  3. D

    In search of 2005 SJB fuse box

    All done. I was able to clean the C210 and the SJB inside and out without breaking anything. I was lucky as I had no green corrosion, just white powder on the pins and relatively little of that. I used CorrosionX on all the pins and their female counterparts to help against future moisture...
  4. D

    In search of 2005 SJB fuse box

    Thanks. When you used them did it require a re programming?
  5. D

    In search of 2005 SJB fuse box

    Please post if you find the part or a rebuilder for yours (to avoid having to have it programmed at the dealer if new or used), seems difficult to find in either case.
  6. D

    2005 GT SJB Issues

    I'm over this particular hurdle. I finally got a good enough look at things to realize that this probably sold as a harness already connected to the C210. Luckily I only have a light white dusting everywhere and will clean that with contact spray. Moving on the SJB itself.
  7. D

    2005 GT SJB Issues

    So actually, I can lift the blue pieces (they seem to be position holders and possibly to help keep moisture out), under them I can see male connectors heading the the center "floatin" board. I haven't yet found how to remove them as a unit, rather than individual wires. Still pushing and...
  8. D

    2005 GT SJB Issues

    That pulls the upper harness from the box. It doesn't seem to do the same for the lower harness. If it should, then it must me mightily stuck in place.
  9. D

    2005 GT SJB Issues

    Does anyone know how to properly disconnect the bottom harness from the C210 connector (grey connector next to the SJB? I can remove the top connector but can't figure out the correct way to release the bottom connector, which is probably a bit corroded inside from water damage. I've attached...
See more

Latest posts

Support us!

Support Us - Become A Supporting Member Today!

Click Here For Details

Back
Top