Recent content by Dcraig10004

Hi guys, are there any freeze plugs on the rear of the engine between the engine and tranny on my 2009 GT?

You need to look at your SJB. There will be two sets of numbers. Both have to be the same. You'll have a part number like 9R3T-14B476-HA and you'll also have a Kit number like 9R3T-15604-HB The replacement has to match exactly. If they do not, then there will be things that do not work. Or do...

GO to the Forscan page https://forscan.org/home.html and you will find the information in the forums section on how to download it and enter in to the as-built-data of the IC so you can turn the TPMS light out permanently.

Yeah, I did that a couple of months ago. All good.

Here is what pulled from AllData. 9R3Z-15604-G

That 282/296 is definitely post-mod, and as mentioned above, it depends on what it was dynoed on. Generally, a Powerdyne Mustang Dyno is very stingy giving the numbers you hope for, but they are true numbers compared to other dynos. Throw a set of cams and a FR intake manifold on, and I think...

Yep. I'm happy with it. Going WOT from 2000-6500 RPMs was a trip, especially with 4:10's. I think I used over 1/4 tank of gas on that pull, lol. That's all I'm doing to her as far as the engine. I would love to get a 6-speed transmission, but the ole lady put the kibosh on that one. Maybe if I...

I just got done having Howards rattler cams installed, brand new coils and plugs, and all new phasers/chains/guides/tensioners installed and had it dyno tuned. I also have a Ford racing intake, a GT500 TB, Pypes LTs, etc, etc.. Anyway since I installed the cams and the timing kit, there is a...

Final Lito tune results in 335 RWHP 321 RWTQ Dynoed on a PowerDyne Mustang Dyno which tend to give more accurate readings than any Dyno.

You bet.

And why in the world would you buy ANYTHING from AutoZone?

Here ya go

I have an Airaid CAI, Pypes LTs, and hi-flow catted x-pipe, Flowmaster outlaw AxleBack, Ford Racing intake, GT500 60mm TB on my '09. Dyno Tuned by my guy here in Pa. Got 309 RWHP and 301 RWTQ. Then I installed Howards Rattler Cams and brand new chains/tensioners/phasers, etc... and the same guy...

Yep. pretty much. I just needed to know if there were any small differences, which there aren't, except Howards doesn't mention anything about removing those 3 roller followers, which I wasn't going to do anyway. But, man when putting the driver's side on, I accidentally knocked on off, and then...

Does anyone have the install manual for Howard's Rattler cams for my 09 GT? They didn't come with one.